User manual MAYTAG MZD2666SS INSTALL

[. . . ] · Open both doors 180°, or as wide as possible. Transporting Your Refrigerator · NEVER transport refrigerator on its side. Allow refrigerator to sit upright for approximately 30 minutes before plugging it in to assure oil returns to the compressor. Plugging refrigerator in immediately may cause damage to internal parts. [. . . ] If required, correct rocking of refrigerator by turning rear adjustment screw clockwise to raise rocking corner. · Turn front roller adjustment screw (A) clockwise to raise front corner of door. · If one refrigerator door has reached the limit of its adjustment range and doors are still not level, raise or lower the opposite door by turning roller adjustment screw clockwise or counterclockwise. · Check with level to verify 1/4" tilt to the back for proper door closure. · Align the toe grille mounting clips with the lower cabinet slots. · Push the toe grille firmly until it snaps into place. CAUTION To avoid property damage or possible injury, follow basic precautions, including the following: · Consult a plumber to connect 1/4" O. D. copper tubing to household plumbing to assure compliance with local codes and ordinances. · Confirm water pressure to water valve is between 35 and 100 pounds per square inch, 20 pounds per square inch without filter. Both reduce water flow and can become clogged over time, and may cause leaks if repair is attempted. · Wait two to three hours before placing refrigerator into final position to check and correct any water leaks. · Verify the copper tubing under the sleeve is smooth and free from defects. Materials Needed: Connecting the Water Supply (select models) WARNING To reduce the risk of injury or death, follow basic precautions, including the following: · Read all instructions before installing ice maker. · Do not attempt installation if instructions are not understood or if they are beyond personal skill level. · Do not service ice maker unless specifically recommended in Use & Care Guide or published user-repair instructions. · Disconnect power to refrigerator before installing ice maker. · Water damage due to an improper water connection may cause mold/mildew growth. [. . . ] Rotate the handle so that the handle is flat against the door (see page 6). The tab on the lower part of the handle will align with the hole in the handle cap. Insert the tip of a flat blade screwdriver between the handle trim and door panel. [. . . ]