User manual MAXTOR XC55

[. . . ] Application Note: SONY XC-55 Camera Descriptions · · · · · Interfacing non-standard cameras to Matrox Pulsar July 18, 2000 646 × 485 × 8-bits. [. . . ] The external trigger is input on the Matrox Pulsar via the analog trigger input. Once this external trigger is received, the Matrox Pulsar generates an EXPOSURE1 (TRIGGER) pulse, which in turn initiates camera exposure. The exposure time is the EXPOSURE1 (TRIGGER) period plus a fixed internal camera delay of 8 µsec. TTL External Trigger Exposure Time EXPOSURE1 (TRIGGER) Delay 8 ms Exposure2 (VD) Video (Video Out) Video Valid Cabling Requirements Mode 1: Continuous · IMG-7W2-TO-5BNC (red BNC) or IMG-7W2-TO-1BNC cable required for video output of camera. Mode 2: Asynchronous reset (E-DONPISHA) · · · IMG-7W2-TO-5BNC and PLS-TTL-CABLE cables required for TTL external trigger signal and for video output of camera. TTL external trigger source should be connected to the TTL trigger input of the IMG-7W2TO-5BNC cable. Connections between the 37-pin connector of the Matrox Pulsar (PLS-TTL-CABLE) and the 12-pin connector of the camera are as follows: Matrox Pulsar (37-pin connector) Pin name TTL_ EXPOSURE1 TTL_ EXPOSURE2 GROUND TTL_ HSYNC continued Sony XC-55 (12-pin connector) Pin name EXT. 09 07 08 06 PUL-CID-052 2 Interfacing non-standard cameras to Matrox Pulsar SONY XC-55 Power Supply Pin name + 12 volts GROUND Sony XC-55 (12-pin connector) + 12 volts GROUND Application Note: July 18, 2000 Cabling Requirements (continued) --- --- 11 10 The DCF(s) mentioned in this application note can be found on the MIL and MIL-Lite CD, or our FTP site (ftp. matrox. com). [. . . ] Dorval, Quebec H9P 2T4 Canada Tel: (514) 685-2630 Fax: (514) 822-6273 PUL-CID-052 3 [. . . ]