User manual MAXTOR VIKING SCSI JUMPERS

[. . . ] Viking: 50-pin Single Ended SCSI Jumper Settings Jumper Settings The following describes the jumper options and settings available on the Maxtor® VikingTM disk drive. [. . . ] The second option jumper block is used to set the Viking termination options. This jumper block is found on the printed circuit board at the rear of the drive and is near the SCSI cable connector. Pin 1 3 5 7 9 11 13 15 17 19 Signal A0 A1 A2 RSVD1 TE LEDPWR Wait Spin Spin Delay RSVD2 RSVD3 Pin 2 4 6 8 10 12 14 16 18 20 Signal logic_gnd logic_gnd logic_gnd logic_gnd logic_gnd LEDPWR logic_gnd logic_gnd logic_gnd logic_gnd 2 of 2 Viking: 50-pin Single Ended SCSI Jumper Settings The drawing above displays the jumper block physical location and pin definitions. SCSI ID Settings The following table identifies the various SCSI ID values and the jumper positions required to set them. Drive ID ID 0 ID 1 ID 2 ID 3 ID 4 ID 5 ID 6 ID 7 A0 OFF ON OFF ON OFF ON OFF ON A1 OFF OFF ON ON OFF OFF ON ON A2 OFF OFF OFF OFF ON ON ON ON 3 of 3 Viking: 68-pin Wide Wide Differential SCSI Jumper Settings Jumper Settings The following describes the jumper options and settings available on the Maxtor® VikingTM disk drive. For more detail on jumper definitions; please refer to the jumper definition section. The Maxtor Viking was developed by Quantum Corporation prior to its merger with Maxtor. Termination Enable (TE) Enable termination Disable termination TE jumper on TE jumper off Termination Power (TP) Enable termination power Disable termination power TP jumper on TP jumper off SCSI ID (A3, A2, A1, A0) 1 of 1 Viking: 68-pin Wide Wide Differential SCSI Jumper Settings Set drive SCSI ID See ID settings table below Wait Spin (WS) Enable spin delay Disable spin delay WS jumper on WS jumper off Spin Delay (SD) Enable spin delay Disable spin delay SD jumper on SD jumper off Jumper Locations The Viking wide disk drive has two locations where user configurable jumpers are found. The primary jumper block (Front option connector J3) the Viking wide drive is found on the front edge of the disk drive printed circuit board. Using these jumper pins you can establish the various drive configuration options. [. . . ] Enable (TE) +5Vdc out Pin 2 4 6 8 10 12 Signal Fault LED logic_gnd logic_gnd Busy LED logic_gnd (reserved) SCSI ID Settings The following table identifies the various SCSI ID values and the jumper positions required to set them. 3 of 3 Viking: 68-pin Wide Wide Differential SCSI Jumper Settings Drive ID ID 0 ID 1 ID 2 ID 3 ID 4 ID 5 ID 6 ID 7 ID 8 ID 9 ID 10 ID 11 ID 12 ID 13 ID 14 ID 15 A0 OFF ON OFF ON OFF ON OFF ON OFF ON OFF ON OFF ON OFF ON A1 OFF OFF ON ON OFF OFF ON ON OFF OFF ON ON OFF OFF ON ON A2 OFF OFF OFF OFF ON ON ON ON OFF OFF OFF OFF ON ON ON ON A3 OFF OFF OFF OFF OFF OFF OFF OFF ON ON ON ON ON ON ON ON 4 of 4 [. . . ]