User manual MAXTOR ULTRA ATA133

[. . . ] Ultra ATA/133 Hard Drive Mounting Kit Installation Guide Ultra ATA/133 Hard Drive Mounting Kit Kit Components · UDMA 133 IDE interface cable · Two 5. 25-inch mounting brackets · Eight mounting screws Tools Required for Installation · A small (#2) Phillips screw driver · Your computer user manual Handling Precautions DO ground yourself before handling the drive to avoid the risk of exposing it to electrostatic discharge. Use a grounding strap or touch a metal part of your computer's case when your system is powered down AND connected to an electrical outlet. [. . . ] Remove the cover from your computer as indicated in your computer user manual. Align the screw holes on one of the included U-shaped mounting brackets with the screw holes on either side of the drive (see figure below). Repeat steps 2 and 3 to attach the second mounting bracket to the other side of the drive. Insert the bracketed drive into the selected 5. 25-inch device bay in your system and use the four remaining screws to attach the drive to the sides of the bay. Be careful not to touch the green circuit board on the bottom of the drive. Note: Make sure the ATA connector end of the drive is facing the interior of your computer case so you can connect the interface and power cables. Mounting Screws 3. Warning: Using any screws except those supplied may cause damage to your drive or system. UDMA Interface Cable Mounting Bracket Computer with available 5. 25-inch device bay Ultra ATA/133 Hard Drive Mounting Kit Attaching the UDMA 133 Cable Determine if the hard drive you are adding will be used in master or slave configuration. Refer to your hard drive installation instructions for proper jumper settings. Tip: A jumper is a small plastic piece that slides over a pair of configuration pins. These configuration pins are usually located adjacent to the ATA connector on the rear of the drive. Connect the cable to the ATA connectors on the hard drive and motherboard/ATA adapter card as shown in the figure below. Be sure to orient each cable connector correctly before inserting it into an ATA connector. [. . . ] Maxtor may make changes or improvements in the product(s) described in this publication at any time and without notice. Other brands or products are trademarks or registered trademarks of their respective holders. [. . . ]