User manual MAXTOR ST52160N INSTALLATION

[. . . ] . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Medalist Pro 2160N (ST52160N) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . SCSI Hard Drive . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Installation Guide . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . -2 Medalist Pro 2160N, Rev. B, September 1999 Seagate, Seagate Technology and the Seagate logo are registered trademarks of Seagate Technology, Inc. [. . . ] If you are creating a partition that will be used to boot your computer (drive C), make sure the partition is marked active. Create an extended partition and additional logical drives, as necessary, until all the space on your new hard drive has been partitioned. When partitioning is complete, FDISK reboots your computer. Drive formatting ! Caution. Make sure to use the correct drive letters so that you do not format a drive that already contains data. At the A: prompt, type format x:, where x is the letter of your new partition. Repeat the format process for all the new partitions you have created. After you format your drive, it is ready to use. You're Done! 14 Medalist Pro 2160N, Rev. B Other operating systems Macintosh To configure your drive for a Macintosh system, you must use a third-party hard disc initialization program. Most software vendors and computer stores that carry Mac software sell hard disc drivers. The Apple HD SC Setup utility included with your Macintosh system software only works on drives ordered directly through Apple. Unix There are several versions of the UNIX operating system. Each of these handle hard disc drive installation in a different manner. For this reason, refer to your system's operating manual for information about how to complete the installation of your disc drive. Netware To configure the drive for Netware, refer to your Netware user's guide for installation instructions. Medalist Pro 2160N, Rev. B 15 Additional drive options 13 11 9 7 5 3 1 14 12 10 8 6 4 2 Parity Enabled Parity Disabled Motor Start Enabled Motor Start Disabled Remote LED connection Figure 7. Options jumper settings The options jumper block allows you to configure your drive for several additional configuration options. The drawing in Figure 7 shows how to place jumpers to enable each optional feature. Also, the drive-activity LED should flash when the power is turned on. If the LED stays on after power-on, make sure the interface cable is properly connected and that no other device on the cable is using the same SCSI ID. Make sure your host adapter is not using an I/O address or interrupt that conflicts with other devices in your system. Host adapters have a diagnostic utility that can help you determine whether such conflicts exist. Each time you add a new device to your computer, make sure your computer's internal power supply can support the total power demand. Before you use someone else's diskette in your system for the first time, scan the diskette for viruses. If you are installing the drive in a network, verify that the drive works with DOS. · Isolate the drive. [. . . ] If your country is not listed here, dial our European call center at +31-20-316-7222 from 8:30 A. M. The European call center is located in Amsterdam, The Netherlands. Call Center Austria Belgium Denmark France Germany Ireland Italy Netherlands Norway Poland Spain Sweden Switzerland Turkey United Kingdom 0 800-20 12 90 0 800-74 876 80 88 12 66 0 800-90 90 52 0 800-182 6831 1 800-55 21 22 800-790695 0 800-732 4283 800-113 91 00 800-311 12 38 900-98 31 24 0 207 90 073 0 800-83 84 11 00 800-31 92 91 40 0 800-783 5177 30 Medalist Pro 2160N, Rev. B FAX Services--All European Countries Presales/Technical Support/Warranty Repair +31-20-653-3513 Africa/Middle East support services For presales, technical support, warranty repair and FAX services in Africa and the Middle East, dial our European call center at +31-20-316-7222 from 8:30 A. M. (European central time) Monday through Friday, or send a FAX to +31-20-6533513. [. . . ]