User manual MAXTOR ST318432 VOLUME 1

[. . . ] . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Cheetah X15 36LP Disc Drive: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ST336752LW/LC, ST336732LW/LC . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ST318452LW/LC, ST318432LW/LC . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Product Manual, Volume 1 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Cheetah X15 36LP Disc Drive: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ST336752LW/LC, ST336732LW/LC . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ST318452LW/LC, ST318432LW/LC . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Product Manual, Volume 1 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ©2001, 2002 Seagate Technology LLC All rights reserved Publication number: 100139872, Rev. D June 2002 Seagate, Seagate Technology, and the Seagate logo are registered trademarks of Seagate Technology LLC. [. . . ] Non-operating ­40° to 158°F (­40° to 70°C) package ambient with a maximum gradient of 36°F (20°C) per hour. This specification assumes that the drive is packaged in the shipping container designed by Seagate for use with drive. HDA Temperature Check Point . 5" 2. 0 " Figure 10. Locations of the HDA temperature check point 6. 4. 2 Relative humidity The values below assume that no condensation on the drive occurs. Operating 5% to 95% non-condensing relative humidity with a maximum gradient of 20% per hour. Operating ­1, 000 to +10, 000 feet (­305 to +3, 048 meters) 28 b. Non-operating ­1, 000 to +40, 000 feet (­305 to +12, 210 meters) 6. 4. 4 Shock and vibration Cheetah X15 36LP Product Manual, Rev. D Shock and vibration limits specified in this document are measured directly on the drive chassis. If the drive is installed in an enclosure to which the stated shock and/or vibration criteria is applied, resonances may occur internally to the enclosure resulting in drive movement in excess of the stated limits. If this situation is apparent, it may be necessary to modify the enclosure to minimize drive movement. The limits of shock and vibration defined within this document are specified with the drive mounted by any of the four methods shown in Figure 11, and in accordance with the restrictions of Section 8. 4. Operating--normal The drive, as installed for normal operation, shall operate error free while subjected to intermittent shock not exceeding 15 Gs at a maximum duration of 11 msec (half sinewave). The drive, as installed for normal operation, shall operate error free while subjected to intermittent shock not exceeding 15 Gs at a maximum duration of 2 msec (half sinewave). Operating--abnormal Equipment, as installed for normal operation, does not incur physical damage while subjected to intermittent shock not exceeding 40 Gs at a maximum duration of 11 msec (half sinewave). Shock occurring at abnormal levels may promote degraded operational performance during the abnormal shock period. Specified operational performance will continue when normal operating shock levels resume. Non-operating The limits of non-operating shock shall apply to all conditions of handling and transportation. The drive subjected to nonrepetitive shock not exceeding 75 Gs at a maximum duration of 11 msec (half sinewave) shall not exhibit device damage or performance degradation. The drive subjected to nonrepetitive shock not exceeding 250 Gs at a maximum duration of 2 msec (half sinewave) does not exhibit device damage or performance degradation. The drive subjected to nonrepetitve shock not exceeding 100 Gs at a maximum duration of 0. 5 msec (half sinewave) does not exhibit device damage or performance degradation. Packaged Disc drives shipped as loose load (not palletized) general freight will be packaged to withstand drops from heights as defined in the table below. For additional details refer to Seagate specifications 30190-001 (under 100 lbs/45 kg) or 30191-001 (over 100 lbs/45 Kg). Package size Packaged/product weight Drop height <600 cu in (<9, 800 cu cm) 600-1800 cu in (9, 800-19, 700 cu cm) >1800 cu in (>19, 700 cu cm) >600 cu in (>9, 800 cu cm) Any 0-20 lb (0 to 9. 1 kg) 0-20 lb (0 to 9. 1 kg) 20-40 lb (9. 1 to 18. 1 kg) 60 in (1524 mm) 48 in (1219 mm) 42 in (1067 mm) 36 in (914 mm) Drives packaged in single or multipacks with a gross weight of 20 pounds (8. 95 kg) or less by Seagate for general freight shipment shall withstand a drop test from 48 inches (1, 070 mm) against a concrete floor or equivalent. Cheetah X15 36LP Product Manual, Rev. D 29 Z Y X Z X Y Figure 11. Recommended mounting 30 6. 4. 4. 2 Vibration Cheetah X15 36LP Product Manual, Rev. Operating - normal The drive as installed for normal operation, shall comply with the complete specified performance while subjected to continuous vibration not exceeding 5-500 Hz @ 0. 5 G (zero to peak) Vibration may be applied in the X, Y, or Z axis. [. . . ] If you need additional help, you can talk to a Seagate technical support specialist. Before calling, note your system configuration and drive model number (ST####). SeaTDDTM (+1-405-936-1687) is a telecommunications device for the deaf (TDD). You can send questions or comments 24 hours daily and exchange messages with a technical support specialist from 8:00 A. M. [. . . ]