User manual MAXTOR SAVVIO SCSI INSTALLATION REV A 4-2004

[. . . ] Keep the drive in its antistatic container until you are ready to install it. · Turn off the power to the host system during installation (not necessary if you are using a hot-plug backplane). · Use caution when troubleshooting a unit that has voltages present. [. . . ] It is not necessary to format a drive that previously has been used to store data, unless your intention is to erase all user data. Savvio disc drives are designed to operate with a variety of operating systems. Please refer to your system or host enclosure manual for information about formatting and setting up the drive. Electromagnetic compliance See Safety and Regulatory Agency Specifications, part number 75789512. Troubleshooting · Drive does not spin up. Ensure that the host system is supplying power to the drive's SCA 80-pin connector and that the drive is fully inserted into the host system's backplane connector. Verify that the drive is enabled by the SCSI host adapter setup utility. Drive characteristics Formatted capacity Total # of data blocks Cylinders (user accessible) Heads Disc rotation ± 5% Operating voltages Typical operating current (amps) ST973401LC 73. 4 Gbytes 143, 374, 744 (88BB998h) 51, 052 4 10, 009 RPM +5V +12V 0. 74 0. 43 ST936701LC 36. 7 Gbytes 71, 687, 372 (445DCCCh) 51, 052 2 10, 009 RPM +5V +12V 0. 69 0. 47 Seagate support services For online information about Seagate products, visit www. seagate. com or e-mail your disc questions to DiscSupport@Seagate. com. If you need additional help, call a Seagate technical support specialist. Before calling, note your system configuration and drive model number. Africa Australia Austria Belgium China* Denmark France Germany Hong Kong Hong Kong India Indonesia Ireland Italy Japan Malaysia Middle East *Mandarin Cantonese Warranty. Seagate Worldwide customer service centers are the only facilities authorized to service Seagate drives. Seagate assumes no responsibility for data lost during shipping or service. © 2004 Seagate Technology LLC All rights reserved Publication number: 100293076, Rev. Seagate and Seagate Technology are registered trademarks of Seagate Technology LLC. Other product names are registered trademarks or trademarks of their owners. Seagate reserves the right to change, without notice, product offerings or specifications. What you need · Screwdriver and four M3 x . 5 metric drive mounting screws · Forced-air ventilation to provide adequate drive cooling · Backplane host system or enclosure that supports SCA 80-pin connectors. [. . . ] In such systems, there are no cables and the drive options, including SCSI IDs, are set either through the host interface or on the backplane. There are no jumpers on the drive that you can use to set the SCSI ID or other drive options. Check your system's documentation to determine how to configure the drive in your particular system. [. . . ]