User manual MAXTOR DIAMONDMAX 22 SERIAL ATA REV A 11-2008

[. . . ] Product Manual DiamondMax 22 Serial ATA STM31000334AS STM3320614AS STM3160813AS 100544218 Rev. A November 2008 Revision history Revision Date Sheets affected or comments Rev. A 11/04/08 Initial release. Copyright © 2008 Seagate Technology LLC. A November 2008 Seagate, Seagate Technology and the Wave logo are registered trademarks of Seagate Technology LLC in the United States and/or other countries. [. . . ] The AFR and MTBF will be degraded if used in an enterprise application Nonrecoverable read errors Annualized Failure Rate (AFR) Contact start-stop cycles Warranty Preventive maintenance 1 per 1014 bits read, max 0. 34% (nominal power, 25°C ambient temperature) 50, 000 cycles (at nominal voltage and temperature, with 60 cycles per hour and a 50% duty cycle) To determine the warranty for a specific drive, use a web browser to access the following web page: support. seagate. com/customer/warranty_validation. jsp None required. 2. 12 2. 12. 1 Agency certification Safety certification The drives are recognized in accordance with UL601950-1 and CSA C22. 2 (950) and meet all applicable sections of IEC950 and EN 60950. 2. 12. 2 Electromagnetic compatibility Hard drives that display the CE mark comply with the European Union (EU) requirements specified in the Electromagnetic Compatibility Directive (89/336/EEC). Testing is performed to the levels specified by the product standards for Information Technology Equipment (ITE). Emission levels are defined by EN 55022, Class B and the immunity levels are defined by EN 55024. Although CE-marked Seagate drives comply with the directives when used in the test systems, we cannot guarantee that all systems will comply with the directives. The drive is designed for operation inside a properly designed enclosure, with properly shielded I/O cable (if necessary) and terminators on all unused I/O ports. Computer manufacturers and system integrators should confirm EMC compliance and provide CE marking for their products. DiamondMax 22 Serial ATA Product Manual, Rev. A 17 Korean RRL If these drives have the Korea Ministry of Information and Communication (MIC) logo, they comply with paragraph 1 of Article 11 of the Electromagnetic Compatibility control Regulation and meet the Electromagnetic Compatibility (EMC) Framework requirements of the Radio Research Laboratory (RRL) Ministry of Information and Communication Republic of Korea. These drives have been tested and comply with the Electromagnetic Interference/Electromagnetic Susceptibility (EMI/EMS) for Class B products. Drives are tested in a representative, end-user system by a Korean-recognized lab. · Family name: DiamondMax 22 · Certificate number: 1000 GB320 GB160 GBAustralian C-Tick (N176) If these models have the C-Tick marking, they comply with the Australia/New Zealand Standard AS/NZS3548 1995 and meet the Electromagnetic Compatibility (EMC) Framework requirements of the Australian Communication Authority (ACA). 2. 12. 3 FCC verification STX- STM31000334AS (B) STX- STM3320614AS (B) STX- STM3160813AS (B) These drives are intended to be contained solely within a personal computer or similar enclosure (not attached as an external device). As such, each drive is considered to be a subassembly even when it is individually marketed to the customer. As a subassembly, no Federal Communications Commission verification or certification of the device is required. Seagate has tested this device in enclosures as described above to ensure that the total assembly (enclosure, disc drive, motherboard, power supply, etc. ) does comply with the limits for a Class B computing device, pursuant to Subpart J, Part 15 of the FCC rules. Operation with noncertified assemblies is likely to result in interference to radio and television reception. This equipment generates and uses radio frequency energy and if not installed and used in strict accordance with the manufacturer's instructions, may cause interference to radio and television reception. This equipment is designed to provide reasonable protection against such interference in a residential installation. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause interference to radio or television, which can be determined by turning the equipment on and off, you are encouraged to try one or more of the following corrective measures: · Reorient the receiving antenna. · Plug the computer into a different outlet so that the receiver and computer are on different branch outlets. If necessary, you should consult your dealer or an experienced radio/television technician for additional suggestions. [. . . ] The diagnostic software ships with all new drives and is also available at: http://seatools. seagate. com. You must have a recent BIOS or software package that supports S. M. A. R. T. Return Status Code in features register D0H D2H D3H D4H D5H D6H D8H D9H DAH Note. If an appropriate code is not written to the Features Register, the command is aborted and 0x 04 (abort) is written to the Error register. 34 DiamondMax 22 Serial ATA Product Manual, Rev. A 5. 0 Seagate Technology support services Online services Internet For information regarding Seagate products and services, visit www. seagate. com. [. . . ]