User manual MAXTOR BARRACUDA ES.2 SAS REV E 4-2009

[. . . ] Product Manual Barracuda ES. 2 SAS ® ST31000640SS ST3750630SS ST3500620SS 100496298 Rev. E, April 2009 Seagate, Seagate Technology and the Wave logo are registered trademarks of Seagate Technology LLC in the United States and/or other countries. Barracuda ES. 2, SeaTools and SeaTDD are either trademarks or registered trademarks of Seagate Technology LLC or one of its affiliated companies in the United States and/or other countries. All other trademarks or registered trademarks are the property of their respective owners. [. . . ] Specified operational performance will continue when normal operating shock levels resume. Non-operating The limits of non-operating shock shall apply to all conditions of handling and transportation. The drive subjected to nonrepetitive shock not exceeding 80 Gs at a maximum duration of 11 msec (half sinewave) shall not exhibit device damage or performance degradation. The drive subjected to nonrepetitive shock not exceeding 300 Gs at a maximum duration of 2 msec (half sinewave) does not exhibit device damage or performance degradation. The drive subjected to nonrepetitive shock not exceeding 150 Gs at a maximum duration of 0. 5 msec (half sinewave) does not exhibit device damage or performance degradation. Shock may be applied in the X, Y, or Z axis. 30 Barracuda ES. 2 SAS Product Manual, Rev. Packaged Disk drives shipped as loose load (not palletized) general freight will be packaged to withstand drops from heights as defined in the table below. For additional details refer to Seagate specifications 30190-001 (under 100 lbs/45 kg) or 30191-001 (over 100 lbs/45 Kg). Package size Packaged/product weight Drop height <600 cu in (<9, 800 cu cm) 600-1800 cu in (9, 800-19, 700 cu cm) >1800 cu in (>19, 700 cu cm) >600 cu in (>9, 800 cu cm) Any 0-20 lb (0 to 9. 1 kg) 0-20 lb (0 to 9. 1 kg) 20-40 lb (9. 1 to 18. 1 kg) 60 in (1524 mm) 48 in (1219 mm) 42 in (1067 mm) 36 in (914 mm) Drives packaged in single or multipacks with a gross weight of 20 pounds (8. 95 kg) or less by Seagate for general freight shipment shall withstand a drop test from 48 inches (1, 070 mm) against a concrete floor or equivalent. Barracuda ES. 2 SAS Product Manual, Rev. Operating--normal The drive as installed for normal operation, shall comply with the complete specified performance while subjected to continuous vibration not exceeding 5 - 22 Hz 22 - 350 Hz 350 - 500 Hz b. Operating--abnormal Equipment as installed for normal operation shall not incur physical damage while subjected to periodic vibration not exceeding: 15 minutes of duration at major resonant frequency Vibration occurring at these levels may degrade operational performance during the abnormal vibration period. Specified operational performance will continue when normal operating vibration levels are resumed. Non-operating The limits of non-operating vibration shall apply to all conditions of handling and transportation. The drive shall not incur physical damage or degraded performance as a result of continuous vibration not exceeding 5 - 22 Hz 2 Gs (0 to peak, linear, swept sine, 0. 5 octive/min) 22 - 350 Hz 350 - 500 Hz 5 Gs (0 to peak, linear, swept sine, 0. 5 octive/min) 2 Gs (0 to peak, linear, swept sine, 0. 5 octave/min) 0. 75 Gs (0 to peak) 0. 25 Gs, Limited displacement 0. 5 Gs 0. 25 Gs Vibration may be applied in the X, Y, or Z axis. Vibration may be applied in the X, Y, or Z axis. 6. 4. 5 Acoustics Sound power during idle mode shall be 2. 9 bels typical when measured to ISO 7779 specification. Sound power while operating shall be 3. 2 bels typical when measured to ISO 7779 specification. There will not be any discrete tones more than 10 dB above the masking noise on typical drives when measured according to Seagate specification 30553-001. There will not be any tones more than 24 dB above the masking noise on any drive. 6. 4. 6 Air cleanliness The drive is designed to operate in a typical office environment with minimal environmental control. 6. 4. 7 Corrosive environment Seagate electronic drive components pass accelerated corrosion testing equivalent to 10 years exposure to light industrial environments containing sulfurous gases, chlorine and nitric oxide, classes G and H per ASTM B845. However, this accelerated testing cannot duplicate every potential application environment. Users should use caution exposing any electronic components to uncontrolled chemical pollutants and corrosive chemicals as electronic drive component reliability can be affected by the installation environment. The silver, copper, nickel and gold films used in Seagate products are especially sensitive to the presence of sulfide, chloride, and nitrate contaminants. [. . . ] Worldwide support is available 24 hours daily by email for your questions. Presales Support: Presales@Seagate. com Technical Support: DiscSupport@Seagate. com Warranty Support: http://www. seagate. com/support/service/index. html mySeagate my. seagate. com is the industry's first Web portal designed specifically for OEMs and distributors. It provides self-service access to critical applications, personalized content and the tools that allow our partners to manage their Seagate account functions. Submit pricing requests, orders and returns through a single, password-protected Web interface-anytime, anywhere in the world. [. . . ]