User manual MAXTOR ATLAS V JUMPERS

[. . . ] Atlas V 68 Pin Jumper Settings Jumper Settings Jumper Settings The following describes the jumper options and settings available on the Maxtor® AtlasTM V disk drive. [. . . ] The alternate jumper block is located at the rear of the drive and is incorporated into the SCSI cable connector. 2 of 7 Atlas V Jumper Settings Pin 1 3 5 7 9 11 13 15 17 19 21 23 25 27 Signal logic_gnd logic_gnd logic_gnd logic_gnd Fault LED logic_gnd logic_gnd NC +5V out logic_gnd logic_gnd logic_gnd logic_gnd Term Power (TP) Pin 2 4 6 8 10 12 14 16 18 20 22 24 26 28 Signal SCSI ID (A3) SCSI ID (A2) SCSI ID (A1) SCSI ID (A0) Blank (Key, no pin) Spin Delay (DS) Force SE (SE) NC Busy Out Write Protect (WP) Stagger Spin (SS) No Wide (NW) Reserved Term Power (TP) 3 of 7 Atlas V Jumper Settings Pin 1 3 5 7 9 11 Signal SCSI ID (A0) SCSI ID (A1) SCSI ID (A2) SCSI ID (A3) NC LED Pwr (+5V) Pin 2 4 6 8 10 12 Signal XTFault logic_gnd logic_gnd Busy LED logic_gnd NC 4 of 7 Atlas V Jumper Settings SCSI ID Settings The following table identifies the various SCSI ID values and the jumper positions required to set them. Drive ID A0 (Pins 7-8) OFF ON OFF ON OFF ON OFF ON OFF ON OFF ON OFF ON OFF ON A1 (Pins 5-6) OFF OFF ON ON OFF OFF ON ON OFF OFF ON ON OFF OFF ON ON A2 (Pins 3-4) OFF OFF OFF OFF ON ON ON ON OFF OFF OFF OFF ON ON ON ON A3 (Pins 1-2) OFF OFF OFF OFF OFF OFF OFF OFF ON ON ON ON ON ON ON ON ID 0 ID 1 ID 2 ID 3 ID 4 ID 5 ID 6 ID 7 ID 8 ID 9 ID 10 ID 11 ID 12 ID 13 ID 14 ID 15 5 of 7 Atlas V 80 Pin Jumper Settings Jumper Settings Jumper Settings The following describes the jumper options and settings available on the Atlas V SCA disk drive. Force SE (SE) (SE jumper located on J7 on PCB) Enable Single Ended operation * Indicates default jumper setting The Atlas V SCA drive does not provide support for any additional options through the use of physical jumper settings. Additional feature options are set through the SCA interface, contact your system manufacturer for details on how to set optional features. The Atlas V SCA provides support for: Stagger Spin, Spin Delay and SCSI ID selection. The Atlas V SCA does not provide support for: SE jumper on Enable auto switch between Single Ended or LVD operation SE jumper off* 6 of 7 Atlas V Jumper Settings Active Termination enable, Termination Power and Write Protect. Jumper Locations The Atlas V SCA disk drive has only one location (J7 on PCB) where user configurable jumpers are found. The jumper block for the Atlas V SCA drive is found on the disk drive printed circuit board near the SCA cable connector. [. . . ] Contact your system manufacturer for details on setting SCSI ID. 7 of 7 [. . . ]