User manual MASTERCRAFT X-30 WAKEBOARD 2001

[. . . ] The use of exposed flames is detrimental to the filters and may cause a fire risk, and must therefore be avoided in all circumstances. Any frying must be done with care in order to make sure that the oil does not overheat and ignite. Accessible parts of the hood may became hot when used with cooking applicance. With regards to the technical and safety measures to be adopted for fume discharging it is important to closely follow the regulations provided by the authorised authorities. [. . . ] This must be completed in accordance with the maintenance instructions provided in this manual). Failure to follow the instructions provided in this user guide regarding the cleaning of the hood and filters will lead to the risk of fires. Do not use or leave the hood without the lamp correctly mounted due to the possible risk of electric shocks. on the product, or on the documents The symbol accompanying the product, indicates that this appliance may not be treated as household waste. Instead it should be taken to the appropriate collection point for the recycling of electrical and electronic equipment. Disposal must be carried out in accordance with local environmental regulations for waste disposal. Use The hood is designed to be used either for exhausting or filter version. Ducting version The hood is equipped with a top air outlet B for discharge of fumes to the outside (exhaust pipe and pipe fixing clamps not provided). If the hood is supplied with carbon filter, then it must be removed. When there is no exhaust duct for venting outdoors, you can use a carbon filter. If the hood is not supplied with carbon filter, then it must be ordered and mounted. The filtered air is returned from atop the cabinet through a duct that passes through the cabinet itself. The diameter of the duct must be the same as that of flange H. The deflector J can be fixed to the outlet hole using the two screws provided. 4-5 Filter version Installation The minimum distance between the supporting surface for the cooking equipment on the hob and the lowest part of the range hood must be not less than 43cm from electric cookers and 65cm from gas or mixed cookers. If the instructions for installation for the gas hob specify a greater distance, this must be adhered to. To remove the grates completely, use the B spring fasteners, which act as pins to hold the grate in place (Fig. Before performing any maintenance operation, isolate the hood from the electrical supply by switching off at the connector and removing the connector fuse. Or if the appliance has been connected through a plug and socket, then the plug must be removed from the socket. Cleaning The cooker hood should be cleaned regularly (at least with the same frequency with which you carry out maintenance of the fat filters) internally and externally. WARNING: Failure to carry out the basic cleaning recommendations of the cooker hood and replacement of the filters may cause fire risks. The manufacturer declines all responsibility for any damage to the motor or any fire damage linked to inappropriate maintenance or failure to observe the above safety recommendations. Description of the hood Grease filter Traps cooking grease particles. If situated inside the support grill, it may be one of the following types: Paper filter must be replaced once a month or if colouring appears on upper side, in such cases the colouring is evident through the grill openings. 8 Sponge filter should be washed with hot soapy water once a month and replaced every 5 to 6 washes. Metallic filter must be cleaned once a month, with non abrasive detergents, by hand or in dishwasher on low temperature and short cycle. When washed in a dishwasher, the grease filter may discolour slightly, but this does not affect its filtering capacity. Removing the Grease Filters (for models wtih grease filter support grates) To remove the dirty grease filter, proceed as follows: a. Remove the pull-out drawer completely and open the ventilation grates that support the grease filters. If special metal filters have been installed, press on the plastic springs R to unhook them (Fig. [. . . ] When washing or replacing the grease filter, wash the grate as well with warm soapy water. Remount the new filter or the old one after it has dried thoroughly. Replacing lamps Disconnect the hood from the electricity. Always replace burnt-out lamps, according to what is provided for your appliance, with olive-shaped max. 40 Watt (E 14) bulbs, or neon-lamp 14 Watt max. , or PL lamp 11 Watt (one PL lamp appliance) or PL 9 Watt (two PL lamp appliance). [. . . ]