User manual MASTERCRAFT X-10 2002

[. . . ] Should the seal not adhere to the casing of the appliance perfectly, it will have to be heated from a suitable distance (by means of hair drier, for example) and lightly stretched to the required height. Changing the Direction of Opening the Door on the Low Temperature Compartment • Unscrew the blocking element and the hinge of the low temperature compartment and take off the door. • Turn the door for 180° and replace it on the opposite side of the low temperature compartment. Fix the hinge and the blocking element of the door (position of holes already provided). 10 Mounting Instructions 1 Cover for the upper hinge 2 Upper hinge 3 Upper rail 4 Slide guide 5 Lower hinge washer 6 Lower hinge fastener 7 Lower hinge 8 Corner without a hole 9 Corner with a hole 10 Low temperature compartment 11 Blocking element 12 Door hinge Mounting Instructions 11 Mounting the Appliance • Push the appliance for some 38 mm into the kitchen unit and allow at least 4 mm free space on both sides between the appliance and the side walls of the kitchen unit (Fig. • Widely open the door and put it together with the kitchen unit door. [. . . ] They were prepared for various types/models of refrigerators therefore you might find in it description of some functions and accesories that your appliance does not have. Tips for Energy Savings • Try not to open the door too often, especially when the weather is wet and hot. • This is especially important if you have an upright model. Mounting Instructions Integrated appliances are equipped with instructions for mounting the appliance into the kitchen unit. 26 Instructions for Use • Every now and then check if the appliance is sufficiently ventilated (adequate air circulation behind the appliance). • Turn the thermostat knob from higher to lower setting as soon as possible (depends on how loaded the appliance is, ambient temperature. . . ). • Before loading the appliance with fresh food, make sure it was cooled to ambient temperature. • Ice and frost layer increase energy consumption, so do clean the appliance as soon as the layer is 3-5 mm thick. • If the gasket is damaged or if it turns out that the sealing is poor, the energy consumption is substantially higher. • The condenser on the rear wall should be always clean, free of dust or any impurities. • Always consider instructions stated in sections Positioning and Energy Saving Tips, otherwise the energy consumption is substantially higher. Important • If you have bought this appliance to replace an old one equipped with a lock that cannot be opened from inside (lock, bolt), make sure that the lock is broken. This will make it impossible for children to lock themselves inside the appliance and suffocate. • If the food has strange smell or colour, throw it away, because it is very likely that it is spoiled and therefore dangerous to eat. • Disconnect the appliance from the power supply before repairing it (only a qualified technician should repair it), before cleaning and before replacing the light bulb. Before pulling the shelf Instructions for Use out, spacers must be moved towards you. Spacers can be also removed, however, it is better to keep them for any later transport. the coldest part of the shelves. Under the plate there is a channel and an outlet for defrost water. Regularly check the defrost water outlet and the channel, because they should never be clogged (as for example with food rests). If clogged, use a plastic straw and clean it. Bottle rack (in some models only) Bottle rack (number depends on model) is intended for storing the bottles. There are two installation positions available (horizontal or lifted in the front) thus enabling the positioning of bottles on the stopper as well. If you want to pull it out, simply lift its rear part and pull it towards you. Fruit and Vegetable Container (3) The container is on the bottom of the appliance under the glass shelf. It provides adequate humidity which has favourable effect on fruit and vegetables stored in it (less dehydration). Door Liner The door liner consists of various shelves or holders used for storing eggs, cheese, butter and yogurt as well as other smaller packages, tubes, cans etc. The lower shelf is used for storing bottles. Illumination in the Interior of the Refrigerator Warning! If the door contains storing shelves, install the rack in such position that the length of the bottles will not hinder the closing of the door. The rack may carry 9 bottles of 0, 75 l or more at the maximum (total weight max. • Pack systematically and make sure that foodstuffs do not touch each other (various odours may mix). • Beverages with high alcohol percentage should be stored in tightly sealed bottles in vertical position. [. . . ] After completed defrosting, turn the knob to desired position and close the refrigerator door. The cause of increased ice formation may be one of the following: − the door does not seal well (clean the gasket if it is contaminated, or replace it if it is damaged); − the door was frequently opened or it was left opened for too long; − the food stored in the refrigerator was warm; − the food or dish is touching the inner back wall. compressor is not operating, the refrigerant flow is heard. This is a normal condition and it has no influence whatsoever on the lifetime of the appliance. • After starting the appliance, the operation of the compressor and the refrigerant flow may be louder, which does not mean that something is wrong with the appliance and it has no influence on the lifetime of the appliance. [. . . ]