User manual MASTERCRAFT MARISTAR 230 SV 2002

[. . . ]  It checks the brightness level of the surrounding environment every 5 seconds.  If battery voltage rises back to 2. 5V or above, it returns to NORMAL MODE.  If the environment remains dark for 72 hours, it commences STOP MODE. (3) STOP MODE (STANDBY):  Occurs when the environment remains dark for 72 hours OR if you manually commence STOP MODE (standby) by covering the solar cell for 10 seconds and then press the RESET key one time. *NOTE: The LCD will display "StP" then turn off and commence STOP MODE. [. . . ] If the solar mode setting is, OFF:  LCD will remain ON constantly. MIN/MAX TEMPERATURE READINGS: VIEW MIN/MAX: Press and release the PLUS button to view:  Outdoor Temperature minimum and maximum. RESET MIN/MAX: Press and hold the PLUS button for 10 seconds to reset the indoor and outdoor minimum and maximum temperatures to current temperatures. 4 DISPLAY MODES: Press and release the SET button to view different display modes:    Outdoor temperature in the first line on the left side and outdoor humidity in the second line on the left side. Shows indoor temperature in the first line on the right side and indoor humidity in the second line on the right. Outdoor temperature in the first line on the left side and outdoor humidity in the first line on the right side. Shows indoor temperature in the second line on the left side and indoor humidity in the second line on the right side. Indoor temperature in the first line on the left side and indoor humidity in the first line on the right side. Shows outdoor temperature in the second line on the left side and outdoor humidity in the second line on the right side Mounting Bracket RESET Button NOTE: Batteries are not replaceable in the sensor. SOLAR-POWERED OUTDOOR TRANSMITTER (915MHZ RECEPTION) The Weather Station receives outdoor data every 48 seconds. If it does not receive the temperature data within 2 minutes after set-up (or the display shows “- - -”), then please check the following points: 1. The distance of the Weather Station or the Sensor should be at least 6 feet (2 meters) away from any interfering sources such as computer monitors or TV sets. Avoid placing the Weather Station onto or in the immediate proximity of metal window frames. Using other electrical products such as headphones or speakers operating on the same signal frequency (915MHz) may prevent correct signal transmission and reception. Do NOT attempt to recharge the included solar-rechargeable batteries outside of the WS-6010U. Use standard alkaline batteries or contact customer support for more information. "Do NOT recharge the included solar rechargeable batteries in any device other than the product they came with. Recharging the alkaline rechargeable batteries in battery chargers or other third party devices will damage the batteries and charging device. " *Once the solar-rechargeable batteries are removed from the Weather Station, slide the battery switch to the left position before replacing the batteries. REGARDLESS OF THE TYPE OF BATTERIES TO BE INSTALLED, THE BATTERY SWITCH MUST BE IN THE LEFT POSITION WHEN THE BATTERIES ARE INSERTED. 6 If new solar rechargeable batteries are used, the battery switch should be moved to the right SOLAR position AFTER they are inserted in the unit. REPLACE INCLUDED SOLAR RECHARGEABLE BATTERIES WITH STANDARD ALKALINE BATTERIES 1. Remove the included solar rechargeable batteries from the compartment. Insert new, 2 x standard alkaline batteries into the compartment, observing the correct polarity (see marking inside battery compartment or on the case). Replace battery cover Note: For best performance, standard alkaline batteries should be replaced at least once every 2 years to maintain the best running accuracy. Ensure that the batteries used are new and the correct size. Please help in the preservation of the environment and return used batteries to an authorized depot. RESTART AFTER STATION HAS BEEN RUNNIING: DISTANCE: For best results, please bring the outdoor sensor in the house and place 5-10 feet from the display unit. DISCHARGE ELECTRICITY: With the power source removed, press one of the buttons on the display at least 20 times to clear all stored power. [. . . ] La Crosse Technology, Ltd will pay all expenses for labor and materials for all repairs covered by this warranty. If necessary repairs are not covered by this warranty, or if a product is examined which is not in need or repair, you will be charged for the repairs or examination. The owner must pay any shipping charges incurred in getting your La Crosse Technology, Ltd product to a La Crosse Technology, Ltd authorized service center. Your La Crosse Technology, Ltd warranty covers all defects in material and workmanship with the following specified exceptions: (1) damage caused by accident, unreasonable use or neglect (including the lack of reasonable and necessary maintenance); (2) damage occurring during shipment (claims must be presented to the carrier); (3) damage to, or deterioration of, any accessory or decorative surface; (4) damage resulting from failure to follow instructions contained in your owner’s manual; (5) damage resulting from the performance of repairs or alterations by someone other than an authorized La Crosse Technology, Ltd authorized service center; (6) units used for other than home use (7) applications and uses that this product was not intended or (8) the products inability to receive a signal due to any source of interference. [. . . ]