User manual MARTIN AUDIO MICT3B 7-1996

[. . . ] The manufacturer cannot be held responsible for damage caused by improper use of the appliance. Before connecting the appliance to the electrical supply, make sure that the voltage and frequency listed on the data plate correspond with the household electrical supply. Be certain your appliance is properly installed and grounded by a qualified technician. To guarantee the electrical safety of this appliance, continuity must exist between the appliance and an effective grounding system. [. . . ] ^ Direct the steam nozzle towards the drip tray and slowly turn the steam selector counterclockwise. ^ Move the pitcher in circles until a thick froth appears, then lower the nozzle deeper into the milk to heat the rest. The foam will collapse and a skin will form. 29 Making coffee ^ Turn the steam off by turning the steam selector clockwise to the "o" position. Carefully pour the milk into the coffee and spoon some froth onto the surface. Always clean the steam nozzle immediately after use, as it is harder to clean once milk has dried. ^ Wipe milk off the nozzle with a damp sponge. 30 Dispensing hot water Hot water ^ Place a cup under the hot water dispenser. ^ Press the hot water button d. Hot water will be dispensed. ^ Press the hot water button d again to stop the hot water flow. The machine will stop automatically if a volume has been programmed in for hot water and feature "Prog. hot water" is activated. 31 Setting the coffee grinder Adjusting the coffee grinder To prevent machine damage, the slide control for the coffee grinder setting should be moved carefully and in small adjustments. ­ If the espresso flows too quickly into the cup, the beans have been ground too coarsely. ­ If the espresso only trickles into the cup, the beans have been ground too fine and the coffee will be bitter. ^ Clean the sleeve with warm water and liquid dish soap (or in the dishwasher) and dry. ^ Push the waste unit back into place, positioning it over the notches. If "Empty waste unit" appears in the message window after cleaning, the waste unit was not seated correctly. The appliance will not operate when this message appears. ^ Slide the sleeve onto the steam nozzle, a, and tighten the screw, b. 37 Coffee system care Brew unit Clean the brew unit by hand only. The moving parts and the rubber gaskets can not be cleaned in a dishwasher. Lubricate the brew unit with the enclosed silicon every 500 cups (see "Lubricating the brew unit"). The brew unit can only be removed after the waste unit has beeen taken out. ^ After cleaning press "PRESS". ^ Push the brew unit in the track straight into the appliance without pressing "PRESS" until it clicks in place. ^ Grasp the brew unit by the handle and press with the thumb on "PRESS". ^ Clean the brew unit thoroughly under running warm water without detergent. One steel filter is in the funnel, the second on the left of the funnel. The second steel filter is removable (see "Cleaning the steel filters". ) 38 Coffee system care Rinsing cycle: Degreasing the brew unit The display will read: The natural oil found in coffee can cause the brew unit to clog. The message "Rinsing cycle" will flash in the message window after 500 cups to remind you to clean the unit with the enclosed detergent tablets. [. . . ] Please contact your local recycling authority about the possibilty of recycling these materials. Ensure that the appliance presents no danger to children while being stored for disposal. Before discarding an old appliance, unplug it from the outlet and cut off its power cord and remove any doors to prevent hazards. 55 Electrical connection , Ensure that power to the appliance is OFF while installation or repair work is performed. All electrical work should be performed by a qualified electrician in strict accordance with national and local safety regulations. [. . . ]