User manual MARTIN AUDIO M

[. . . ] The manufacturer cannot be held responsible for damages caused by improper use of the hood. Improper use of the appliance can lead to personal injury and material damage. READ AND SAVE THESE INSTRUCTIONS This appliance is designed to vent cooking smoke and odors only. Be certain your appliance is properly installed and grounded by a qualified technician. [. . . ] Stainless steel Stainless steel surfaces can be cleaned using a non-abrasive stainless steel cleaner. To help prevent resoiling, a conditioner for stainless steel can also be used. Stainless steel colored controls These controls may become discolored or damaged if not cleaned regularly. Do not use a stainless steel cleaner on these controls. Cleaning the casing scouring pads, steel wool or caustic (oven) cleaners on the hood. ^ All external surfaces and controls can be cleaned with warm water and liquid dish soap applied with a soft sponge. Avoid: ­ cleaning agents containing soda, acids or chlorides, ­ abrasive cleaning agents e. g. pot scourers or sponges which have been previously used with abrasive cleaning agents. These will damage the surface. , Never use abrasive cleaners, 16 Cleaning and Care Grease filters The reusable metal grease filters remove solid particles from the vented kitchen air (grease, dust, etc). Depending on the detergent, cleaning the grease filters in a dishwasher may cause permanent discoloration of the filter surface. ^ While the filters are removed, clean any dirt or grease from the filter casing to prevent the risk of fire. When putting the grease filters back make sure that the locking clips are visible facing down towards the cooking surface. (S8 wall anchors included in the packaging are not for use in USA / CDN. ) 25 Plywood backing The majority of the weight of the installed ventilation system will be supported by retaining plate A. If studs are not available in the required locations, a plywood backing (min. 1 /2" (13 mm) thick) spanning at least two studs must be installed. Failure to adequately support the weight as stated may result in the ventilation system falling off the wall, causing personal injury and property damage. ^ Hold retaining plate A against the wall so that the marks are visible through the holes of the plate (see "Installation / Retaining plate A"). Draw a line around the plate's perimeter, then set aside the plate. ^ Make a cutting line 3" (76 mm) above and 3" (76 mm) below the outline of plate "A". ^ Find the studs to the left and right of the mounting location by tapping the wall or using a stud finder. Be careful not to damage any wiring or plumbing that may be located behind the wall. Make sure that the power supply to the area where this installation is being performed has been turned off at the breaker panel before cutting into the wall. ^ Remove the drywall between the cutting lines and replace it with plywood of a matching thickness (min. [. . . ] For air extraction, the vents are not required and are covered by the chimney. Recirculation Air extraction ^ Pull the chimney extension slightly outwards and snap over the upper retaining plate B. When installing for recirculation, ensure that the vents are positioned so they line up with the diverter. 37 Installation Attaching the chimney ^ Screw the extension piece firmly to the upper retaining plate using two 3. 9 x 7. 5 mm screws. ^ Cover the screws with the supplied cap covers. ^ Fold the protective shield at the top. ^ Stick the shield to the chimney extension so that it is smooth and flush with the bottom. ^ Only for recirculation: With the slats pointing downwards, install the recirculation vents through the extension piece and into the diverter. ^ Remove the protective foil from the chimney. [. . . ]