User manual MARMITEK SPLIT312

[. . . ] To prevent short circuits, this product should only be used inside and only in dry spaces. Do not expose the components of your systems to extremely high temperatures or bright light sources. In case of improper usage or if you have altered and repaired the product yourself, all guarantees expire. [. . . ] Do not use much force to connect or disconnect the HDMI cables otherwise they may become damaged. The maximum resolution that can be used is entirely dependent on the HDMI source and the connected HDMI screens. The resolution of the HDMI source must be set so that both HDMI screens support it. check the instructions for the connected HDMI equipment to verify the maximum supported resolution and how this can be set. Once all equipment is connected and set in the correct way, switch everything off and then on again. Select the correct HDMI input on your HDMI screen and you should then see the same signal on each screen, with the same resolution. Tip for usage: Ensure that the HDMI source and screens fully support the HDCP protocol in order to prevent any problems. No (or bad) image and sound If you see a bad image or no image at all after connecting the HDMI splitter, try to establish what the problem is by connecting your devices, one by one, to your screen (TV, monitor or projector). This will allow you to establish whether the problem lies in the HDMI sources, the HDMI cables, the HDMI splitter or the screen. HDMI equipment that has not been tested and certified by ATC (Authorized Test Centers) may cause image and sound problems. Check whether the Split312's power adapter is connected and plugged in; · use the highest quality HDMI certified cables (category 2 HDMI certified); · Do not use HDMI cables that are longer than specified in the technical data; · Check whether the HDMI cables and/or connectors are damaged; · Both the HDMI source as well as your screen must fully support HDMI; 4 © MARMITEK Do you have a question that has not been answered here?Check whether your HDMI sources and screen support HDCP (High-bandwidth Digital Content Protection). It is possible to transfer the signal over longer distances using a wire or wirelessly, to another room in your house, by expanding the Split312 with a MegaView61 or the GigaVideo800 HDMI. Infrared extension Marmitek offers several products to operate your devices, even when these are placed in a closed cupboard or in a different room. [. . . ] Correct disposal and recycling will help prevent potential negative consequences to the environment and human health. For more detailed information about the disposal of your old equipment, please contact your local authorities, waste disposal service, or the shop where you purchased the product. Hereby, Marmitek BV, declares that this SPLIT312TM is in compliance with the essential requirements and other relevant provisions of the following Directives: DIRECTIVE 2004/108/EC OF THE EUROPEAN PARLIAMENT AND OF THE COUNCIL of 15 December 2004 on the approximation of the laws of the Member States relating to electromagnetic compatibility Directive 2006/95/EC of the European Parliament and of the Council of 12 December 2006 on the harmonisation of the laws of Member States relating to electrical equipment designed for use within certain voltage limits Directive 2002/95/EC of the European Parliament and of the Council of 27 January 2003 on the restriction of the use of certain hazardous substances in electrical and electronic equipment Hiermit erklärt Marmitek BV die Übereinstimmung des Gerätes SPLIT312TM den grundlegenden Anforderungen und den anderen relevanten Festlegungen der Richtliniën: RICHTLINIE 2004/108/EG DES EUROPÄISCHEN PARLAMENTS UND DES RATES vom 15. [. . . ]