User manual MARMITEK SPEAKER ANYWHERE 200

[. . . ] Marmitek does not accept responsibility in the case of improper usage of the product or when the product is used for purposes other than specified. Marmitek does not accept responsibility for additional damage other than covered by the legal product responsibility. Do not open the product (battery panel excepted): the device may contain live parts. [. . . ] With batteries Insert 6 pieces `AA' size ALKALINE battery into the battery compartment with correct polarity. For using the batteries, make sure the Power adapter is not connected. With supplied power adapter Connect the 12V power adapter to the Power connection (DC IN) on the rear of each speaker, then plug it to the electrical wall outlet. Switch on the speakers by turning up the VOLUME ON / OFF button towards ON direction. Switch off the speakers by turning down the VOLUME ON/OFF button towards OFF direction until a "click" sound is heard. Turn on the audio source (TV, PC, Radio, CD-/MP3-/MP4-/DVD player) to which the transmitter is connected. Tipp: for crystal clear sound, put the volume of the audio source higher and adjust the volume of the speakers to the desired level. Therefore put the speakers and transmitter together (max 7meters in-between). When the button is pressed, frequency tuning starts automatically and it stops when a signal is detected. Whenever you find frequency jam, move your channel switch from one channel to the other channel (there are two channels for selection) on the back of the transmitter, and then press the "AUTO TUNING" button on the speaker again. Turn bass/boost effect ON simply by pressing the button down, and pressing it once again to OFF. Turn the VOLUME ON/OFF button until the click sound is heard to turn off the speaker and the LED light goes off. For protection of the transmitter and power saving, the transmitter will shut down automatically if there is no/weak input signal from audio source for 4 minutes. If the signal comes back, the transmitter will work again automatically. * the power adapter is fully inserted into the wall outlet and the Power connection (DC IN) on the transmitter and speaker. Replace with new batteries or connect a power adapter to the speakers. [. . . ] For more detailed information about the disposal of your old equipment, please contact your local authorities, waste disposal service, or the shop where you purchased the product. Hereby, Marmitek BV, declares that this SPEAKER ANYWHERE200 is in compliance with the essential requirements and other relevant provisions of the following Directives: Directive 1999/5/EC of the European Parliament and of the Council of 9 March 1999 on radio equipment and telecommunications terminal equipment and the mutual recognition of their conformity DIRECTIVE 2004/108/EC OF THE EUROPEAN PARLIAMENT AND OF THE COUNCIL of 15 December 2004 on the approximation of the laws of the Member States relating to electromagnetic compatibility Directive 2006/95/EC of the European Parliament and of the Council of 12 December 2006 on the harmonisation of the laws of Member States relating to electrical equipment designed for use within certain voltage limits Directive 2002/95/EC of the European Parliament and of the Council of 27 January 2003 on the restriction of the use of certain hazardous substances in electrical and electronic equipment Hiermit erklärt Marmitek BV die Übereinstimmung des Gerätes SPEAKER ANYWHERE200 den grundlegenden Anforderungen und den anderen relevanten Festlegungen der Richtliniën: Richtlinie 1999/5/EG des Europäischen Parlaments und des Rates vom 9. Copyright and all other proprietary rights in the content (including but not limited to model numbers, software, audio, video, text and photographs) rests with Marmitek B. [. . . ]