User manual MARMITEK GIGAVIEW 820

[. . . ] Marmitek does not accept responsibility in the case of improper usage of the product or when the product is used for purposes other than specified. Marmitek does not accept responsibility for additional damage other than covered by the legal product responsibility. Do not open the product (battery panel excepted): the device may contain live parts. [. . . ] Plug the IR Sensor Extender cable into the IR IN connector on the GV820 Receiver and place this in sight of the Remote Control. plug the IR LED Extender cable into the IR OUT connector on the GV820 Transmitter. This will now send all received infrared commands via the IR Sensor Extender cable. Once the Power Supply has been inserted into the socket, the GV820 will switch itself ON. NB: Use the 2 plugs and 2 screws if you wish to attach the GV820 Receiver to the wall (e. While warming up, the Power LED will flash blue until the signal connection between the Transmitter and Receiver has been established. NOTE: the Transmitter and Receiver must be at least 2 metres apart to have a good connection. Set the HDTV or HD projector (in HDMI mode) and the HD device that you wish to watch ON. Press the SOURCE button until you see the video images from your device. The time it takes to switch between sources may be about 15-20 seconds. If you have electrical equipment, such as wireless telephones or internet, that work on the 5GHz frequency it may impact upon the sound and picture quality of the GV820 set. Press the CHANNEL button on the Remote Control in order to select another channel (see `Channel Frequency' appendix for an overview). If everything is working correctly, the POWER LED and SOURCE LED will be constantly blue (see table if this is not the case). System is starting up, wait at least 1 minute to establish a connection. Flashes 3x per second Static blue Flashes 1x per second Connection between Transmitter and Receiver Video resolution is not supported Video resolution is recognised and connection between transmitter and receiver is stable. Press once to show this information on the HDTV or Projector connected to the Receiver. Shows information about `Channel', the selected `Source' and the `Signal Quality' Switches between Source 1 and Source 2. Manually choose another frequency if you have sound or picture problems. [. . . ] Permitted to use Ónly for indoor applications, closed industrial and warehouse areas, and on board aircraft. Marmitek recommends that you check with the local authorities for the latest status of their national regulations. Copyright and all other proprietary rights in the content (including but not limited to model numbers, software, audio, video, text and photographs) rests with Marmitek B. [. . . ]