User manual MARMITEK EASYTOUCH 35 BROCHURE

[. . . ] Safety Warnings __________________________________________________________4 Introduction _____________________________________________________________5 Installing the batteries ____________________________________________________6 Description of the ET35 "rubber" keys _______________________________________6 Description of the ET35 "Touchscreen" keys __________________________________7 Programming the EasyTouch35 ____________________________________________9 Method A: Programming using the Brand Search method _______________________9 Method B: Programming using the 3 Digit Code Tables ________________________10 Method C: Programming using the Manual Code Search-method _______________11 Identifying codes found using the search procedures __________________________12 Programming a Macro____________________________________________________12 Channel toggle key ______________________________________________________14 Setting key labels ________________________________________________________15 Code learning___________________________________________________________16 Marmitek X-10 Home Automation _________________________________________17 12. To prevent short circuits, this product should only be used inside and only in dry spaces. Do not expose the components of your systems to extremely high temperatures or bright light sources. The product should only be repaired or serviced by a qualified repairman In case of improper usage or if you have opened, altered and repaired the product yourself, all guarantees expire. [. . . ] Total number of 20 keystrokes can be stored under each of the 9 available Macro keys. Press and hold Setup key until the LED remains on (this occurs after approximately 2-3 seconds) and the display shows the Main Setup Screen. Press and release the remote keys (maximum of 20) that are required to be stored in the exact order that they should be transmitted. Use the Touchscreen "SCREEN" key to toggle the screen keys displayed and use the Mode keys for any Mode changes. Note - if you program the maximum of 20 keys, then the Macro will be automatically stored on the 20th keypress. Press and release the Touchscreen "EXIT" key to return to normal operation. It may be necessary to have "delays" included in the Macro sequence (e. First Setup keypress takes you to the "Delay" screen and the second Setup press results in abort and exit. Press and hold the Setup key until the LED remains on (this occurs after approximately 2-3 seconds) and the display shows Main Setup Screen. The Channel-Toggle "P<P" key is a special type of Macro key. The feature allows you to program in two specific fixed channels and switch between them with a single key-press. Each set of data can be up to 4 key-presses and must be a minimum of 2. The following keystrokes can be any other key (except for Mode, Macro, Setup and Screen) although in practice, these keys will usually be digit keys. Press and hold Setup key until the LED remains on (this occurs after approximately 2-3 seconds) and display shows the Main Setup Screen. Use the "SCREEN" Key to toggle the screen keys displayed ­ this counts as a keypress. If less than 3 keys are required then press the Mode key and go directly to Step 7. To enter the second set of data, press and release desired Mode key (TV, VCR, SAT, etc. Press and release the Touchscreen "EXIT" key to return to normal operation. To activate the Channel-Toggle function, press and release the Touchscreen "P<P" key repeatedly to alternate between the two sets of data you entered. You can select which keys are shown or "hidden" in the display for each of the Device Modes. You can select any Touchscreen key for change except for the SCREEN, SLEEP, SEARCH and P<P keys. Press and hold Setup key until the LED remains on (this occurs after approximately 2-3 seconds) and display shows the Main Setup Screen. [. . . ] DVD), Cable or SAT library device without the need to change to TV Mode. This feature is also available if the Marmitek X-10 Home Automation key is programmed to control a second VCR, Cable or SAT device. Press and release the TV mode key (TV must be in TV mode for this procedure). The LED will blink, and stay off for the 5 second period then blink once more to indicate volume toggle acceptance. [. . . ]