User manual MARMITEK EASYCONTROL 8 BROCHURE

[. . . ] To prevent short circuits, this product should only be used inside and only in dry spaces. Do not expose the components of your systems to extremely high temperatures or bright light sources. The product should only be repaired or serviced by a qualified repairman In case of improper usage or if you have opened, altered and repaired the product yourself, all guarantees expire. Marmitek does not accept responsibility in the case of improper usage of the product or when the product is used for purposes other than specified. [. . . ] [22] REC (Record) This button works just like the one on your original VCR remote control. To avoid recording something accidentally, you must press this button twice to record. With these buttons you can execute a series of pre-programmed commands with one press of a button. In order to prepare your remote control to work with your equipment, you need to program it once. This is done by entering the code for the brand and type of device that you want to operate with this remote control. For example, if you have three video recorders, you can assign video recorder 1 to the VCR button, assign video recorder 2 to the DVD button and video recorder 3 to the SAT button. If there is more than one code, it depends on the type of device which code you need to use. It is possible you may have to try various codes before you find the correct code for your device: 1. Press SETUP (9) and keep this button pressed until one of the mode LEDs stays lit. Press the Mode button (2) for the device that you want to operate (for example TV) and release this button. Repeat the procedure from step 1 for any other device that you wish to program (video, DVD player, satellite, etc). 2 Automatically search for common brands If your brand is listed here, you can search by brand (this is quicker than searching manually or automatically) Turn the device you want to operate on. Press SETUP (9) and keep this button pressed until one of the mode LEDs stays lit. Enter the code matching your brand, point the EasyControl 8 remote control at the device and press Prog+ (6) once. Keep the remote control pointed at the device until it changes channel. If you accidentally miss the code, you can stop the search by pressing Prog- (6) and go back to the correct code by repeatedly pressing this button. Note: If certain functions of your device do not work, try the next code for your brand. If that was 030, the search function will begin at 031 and will continue until the last possible code. When you are looking for an unknown code, you can automatically search through all the codes (AutoSearch). Note: Because you can assign every device (DVD, satellite) to the VCR, CBL, DVD, AUDIO and ASAT and DSAT buttons, you first have to enter a 3-digit code for the type of device that you want to operate (see the code book). For example: If you want to program a satellite on the DVD button, you first have to enter a RANDOM satellite code from the code book and follow the following steps: 1. Press SETUP (9) and keep this button pressed until one of the mode LEDs stays lit. [. . . ] The buttons will be executed by the macro in the same order as they are programmed. If you have used up the maximum of 10 commands, the procedure will stop automatically and the 10 commands will be saved under the Macro button you are setting. Use the numerical keys to select the UnitCode of the Module of your choice (1-digit codes do not have to preceded by a `0'). In most cases you do not need to change this setting, unless another X-10 system in your area causes interference. [. . . ]