User manual MARMITEK DOORGUARD 400

[. . . ] Marmitek does not accept responsibility in the case of improper usage of the product or when the product is used for purposes other than specified. Marmitek does not accept responsibility for additional damage other than covered by the legal product responsibility. the product should only be repaired or serviced by a qualified repairman. [. . . ] This way, a link is made in the door-contact, and that way the door can be opened from any connected monitor. Take the monitor and attach the connector(s) of the cable(s) in the right connectors (see figure 5). Now place the monitor against the wall plate and move it up and down against the plate such that it snap-locks onto the plate. Your DoorGuard400TM has now been successfully installed and is ready for use. As soon as a visitor rings the doorbell by pressing on the doorbell button, the image will appear instantly on the monitor in the house. This way you can see who is at the door before you decide to open it (or pretend you're not at home). If you have also installed an electric door opener, you can open the door by pressing on the door-open button (15). You have installed multiple monitors in the house (maximum 3 extra), then you can talk among each other using the intercom button (14). the door-open-contact of the monitor is a potential-free normally-open (NO) contact. - You need to connect the door opener onto the L+ en L- connectors of the monitor, using the supplied cable. Connecting multiple monitors - To be able to see who is at the door from several places (max. Beware: Only the last monitor that you connect should be switched on 75 Ohm. to connect the extra monitor , the 10meter connection cable is provided with an extra connector at the monitor end. However, it is important that there be sufficient room behind the monitor for the attachment of the connectors. If you want to bridge a greater distance, then check out the following table for the required cable type. Marmitek Camera corner bracket mounting To be able to mount your DoorGuard400 camera in the corner of the door frame. [. . . ] Placez maintenant le moniteur contre le support mural et bougez-le (de haut en bas) de telle façon que le moniteur se glisse par-dessus le support mural et se fixe avec un clic. Hereby, Marmitek BV, declares that this DoorGuard400 is in compliance with the essential requirements and other relevant provisions of the following Directives: Council Directive 89/336/EEC of 3 May 1989 on the approximation of the laws of the Member States relating to electromagnetic compatibility Council Directive 73/23/EEC of 19 February 1973 on the harmonization of the laws of Member States relating to electrical equipment designed for use within certain voltage limits Hiermit erklärt Marmitek BV die Übereinstimmung des Gerätes DoorGuard400 den grundlegenden Anforderungen und den anderen relevanten Festlegungen der Richtliniën: Richtlinie 89/336/EWG des Rates vom 3. Copyright and all other proprietary rights in the content (including but not limited to model numbers, software, audio, video, text and photographs) rests with Marmitek B. [. . . ]