User manual MARMITEK CONNECT420

[. . . ] Marmitek does not accept responsibility in the case of improper usage of the product or when the product is used for purposes other than specified. Marmitek does not accept responsibility for additional damage other than covered by the legal product responsibility. Do not open the product (battery panel excepted): the device may contain live parts. the product should only be repaired or serviced by a qualified expert. [. . . ] Deep Color 36-bit (billions instead of millions of colours, better reproduction of subtle gradation variances and higher contrasts). Connect the power adapter to the Connect420 and plug into the electrical socket. Pull the plastic strip out of the battery compartment on the remote control in order to activate the battery and enable use of the remote control. Remove the protective film (prevents scratching) on top of the remote control and from the `Select' button on the front of the Connect420. Automatically switch between HDMI sources When one of the HDMI sources is used, the Connect420 will automatically switch to the appropriate input channel. If numerous HDMI sources are already in use, the Connect420 will automatically switch to the most recently active HDMI source. Manual switching between HDMI sources The `Select' button on the front of the Connect420 can be used to manually switch between the various HDMI sources. The LED lights on the front of the panel indicate which source is active. No (or poor) image and sound If you experience poor or no image after connecting the HDMI switcher, try to recover the problem by connecting the devices one at the time to your screen (TV, monitor or projector). This way you can determine whether the problem lies with the HDMI sources, the HDMI cables, the HDMI switcher or the screen. HDMI devices which are not tested and certified by ATC (Authorized Test Centers) can cause image and sound problems. Check if the power adaptor of the Connect420 is connected and plugged into the mains. Only use High Speed HDMI® certified cables for the best picture and sound quality. Do not use HDMI cables that are longer than specified in the technical data. Check whether your HDMI sources, DVI device and screen support the copy protection HDCP (High-bandwidth Digital Content Protection). No proper 3D picture · Check whether the HDMI source has been set to 3D and/or that this is set to automatic. Both the HDMI source as well as the HD screen must support the same 3D formats. Check whether the proper 3D picture is reproduced by directly connecting the HDMI source to the screen with an HDMI cable. [. . . ] Correct disposal and recycling will help prevent potential negative consequences to the environment and human health. For more detailed information about the disposal of your old equipment, please contact your local authorities, waste disposal service, or the shop where you purchased the product. Hereby, Marmitek BV, declares that this Connect420TM is in compliance with the essential requirements and other relevant provisions of the following Directives: DIRECTIVE 2004/108/EC OF THE EUROPEAN PARLIAMENT AND OF THE COUNCIL of 15 December 2004 on the approximation of the laws of the Member States relating to electromagnetic compatibility Directive 2006/95/EC of the European Parliament and of the Council of 12 December 2006 on the harmonisation of the laws of Member States relating to electrical equipment designed for use within certain voltage limits Directive 2002/95/EC of the European Parliament and of the Council of 27 January 2003 on the restriction of the use of certain hazardous substances in electrical and electronic equipment Hiermit erklärt Marmitek BV die Übereinstimmung des Gerätes Connect420TM den grundlegenden Anforderungen und den anderen relevanten Festlegungen der Richtliniën: RICHTLINIE 2004/108/EG DES EUROPÄISCHEN PARLAMENTS UND DES RATES vom 15. Copyright and all other proprietary rights in the content (including but not limited to model numbers, software, audio, video, text and photographs) rests with Marmitek B. [. . . ]