User manual MARMITEK 4IN1

[. . . ] [6] Ent (Enter): Used in conjunction with the numeric keys for direct channel tuning. Correct use This remote control unit is capable of controlling most television sets, video-recorders, and satellite recievers generally available on the market. you will find the codes for the most frequently available equipment in the code list for the 4IN1 remote control unit. [. . . ] 3 Code library The codes for the most frequently available television sets, video recorders and satellite recievers are available in the code list library, and a complete list in the Code List attached to these usage instructions. Note: The three-digit code numbers allocated in this library are not the same as the ones in the code libraries drawn up by other manufacturers. 4 Punch Through The punch through allows the user to activate the "volume" and "mute" controls of the television set even when the remote control unit is in "VCR" or "SAT" mode, without having to switch back to "TV". 5 Entering codes directly from the code library The codes for the various items of equipment can be found in the code list attached to these instructions. Press the "SETUP" button and hold it down until the diode lights up. If an invalid code is entered, the diode will flash for three seconds before going out. NOTE: If a number of codes are shown for one manufacturer, please try them all out until you find the right one. After the code has been entered, check that the television set reacts correctly to commands from the remote control unit. If no functioning code can be found under the name of the manufacturer, a code search will have to be carried. 6 Code search You have the facility available of searching through the all codes in the library in order to find a certain television set that does not appear in the library list or that does appear in the library but under another manufacturer's name. ) on manually that you wish to control Press the "SETUP" button down and hold it down until the diode lights up. ) Press the "CHANNEL +" button (next channel upwards in the list), or "POWER', or "PLAY" (only applies to VCR) as many times as necessary until the equipment that is to be controlled changes channel or reacts appropriately. If the user accidentally overshoots the required code, he or she should press the "REW" (symbol) button as many times as necessary to go back through the library until the equipment changes channel or reacts appropriately. The transfer of the code from the code-search mode has now been completed. Note: If the equipment does not possess a "CHANNEL+" button, use the "PLAY" (only on VCR) or "POWER"button. If the mode contains 100 codes and the one stored at that moment is 050 the search will start at 051 and run through to 100, then jump back to 000 and continue searching through to 050. This simplifies the procedure of more than one code can control your equipment because it skips the ones it has already tested. Note: It should be noted, when entering or searching for codes, that the correct code is not entered until the television set is completely capable of being operated. [. . . ] Use the number buttons to enter the Unit Code number of the chosen Module (You do not need to enter `0' first for a single digit number). Changing the X-10 House Code The Marmitek 8 in 1 remote defaults to House Code A, and in most cases you will not need to change this unless you are experiencing interference form a neighbouring X-10 system. Use the number button to enter the number equivalent to the chosen House Code (1=A, 2=B, . [. . . ]