User manual MARANTZ WB6001

[. . . ] Model WB6000 User Guide 61" Plasma Wall Mount INTRODUCTION INTRODUCTION Thank you for purchasing the MARANTZ WB6000 Plasma Display Mounting System. This system has been specially designed using high quality steel for stability and ease of installation. [. . . ] Marantz will not assume any responsibility for damage resulting from the use of improper mounting hardware. > The intended flat surface should be capable of supporting a weight of 4 times the weight of the Plasma Display plus the weight of the mount (25 lbs. ) and the associated equipment. If you are in doubt, consult your with your Marantz Authorized Dealer or a professional home theatre installation specialist. > Have the help of two people or more when you attempt to mount the Plasma to the already-mounted Marantz Plasma Mount Hardware. Plasma Displays are heavy and difficult to handle for one person. > DO NOT subject the unit or supporting structure to shock, vibration, movement or danger of impact which could result in damage to your Plasma Display or personal injury. > DO NOT mount in direct sunlight, or near a heater, fireplace or air conditioner which could result in damage to your Plasma Display or increase the risk of fire. Wall > Ventilation is Required. To allow heat to disperse, leave space between surrounding objects as shown on the diagram at right when installing. 50mm (2") 50mm (2") 50mm (2") Wall CAUTION!Failure to adhere to the precautions listed above may result in damage to your Plasma Display or injury to your person. 3 mm (2") 50mm (2") INSTALLATION MOUNTING HARDWARE Mounting Hardware Machine Screw M8 x 30mm Spacer 8mm Spacer Screw Assembly Flat Washer Flat Washer Machine Screw PREPARING FOR INSTALLATION The Marantz Plasma Wall Mount is designed for mounting on a flat surface. The mounting 'slots' will give you 7 inches (17. 78 cm) of lateral shift movement so that the mount can be more easily centered on the wall. The Marantz Plasma Wall Mount provides a Screw Kit for your Plasma Display. Lay your Plasma Display face down on a soft flat surface, such as carpeting, and screw the 'Screw Assembly' (provided) into the mounting holes in the back of the Plasma Display. MOUNTING THE PLASMA MOUNT SYSTEM Locate the wall studs nearest your mounting location and drill pilot holes (at least four) for 5/16" (0. 794 cm) Lag Bolts with washers for studded walls, or appropriate anchors for your mounting surface. Marantz assumes no responsibility for improper use of mounting hardware. Use the Marantz Plasma Wall Mount for a template for vertical spacing if you prefer. [. . . ] Have one or more persons on each side of the Plasma Display and lift it into a vertical position so that you can see the mounting screws in the back of the display and see the mounting key holes on the Plasma Wall Mount. Gently lower the screws into the 450 (degree) key holes and down to the left 1/2". 4 INSTALLATION INSTALLATION MOUNTING THE PLASMA WALL MOUNT MOUNTING FOR HORIZONTAL PLASMA POSITION Figure: 1 16" wall studs wall OPTIONS OPTIONS > > Tilt-Mount Option: Please refer the TK6540 User Guide Table-Top Stand Option: Please refer the PL6540 User Guide You can find your nearest authorized distributor or dealer on our website at: www. marantz. com 110 Maplewood Drive Itasca, IL 60143 Phone: 630 741-0300 Fax: 630 741-0301 5 [. . . ]