User manual MARANTZ ST-17

[. . . ] R Model ST-17 User Guide Stereo Tuner FRANÇAIS ENGLISH CAUTION ENGLISH FRANÇAIS NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. [. . . ] * When a station other than a preset station is selected, and the CHAR. button is pressed, the frequency indicator will remain lit, the "PRESET" indicator will flash and the station name can not be registered. Use the GYRO CONTROL ring to input the desired number or letter at the first flashing digit on the left side. When turned to the left, input will change in the following order: 9 ­ 0 . . Press the ST NAME button when the first digit on the left has been input. Input the desired number or letter using the same procedure as in step 3, and press the CHAR. (The flashing position will move each time the ST NAME button is pressed. ) 5. * Although station names of up to 8 characters can be input, even if a station name that is under 8 characters is input, pressing the MEM0 button will finish registration at that point. DELETING THE CONTENTS OF THE PRESET MEMORY 1. 5 sec. ), turn the GYRO CONTROL ring to set the preset number to "00". The preset number and the "CLEAR" indicator will flash for approx. Station names memorized for the preset station will also be deleted at the same time. <GYRO RING operation method> When the GYRO ring is turned to the right, the frequency or preset number will increase, and when turned to the left, they will decrease. CHANGING STATION NAME To change registered station names, carry out steps 2 to 5 of the registration procedure. The old station name will be replaced with the new one. TO ERASE STATION NAMES 1. The station name will be erased, and the frequency display will be returned to. 6 BAND DISPLAY MEMO PRESET PRESET 1 MONO 2 5 8 0 3 6 9 Number buttons Press 1 5 MONO button 4 MEMO 7 MEMO button Press Press within 1. 5 sec. Example: To preset under preset no. 3. MEMO PRESET PRESET 3 TUNING PRESET RC-17ST TUNING UP/DOWN buttons PRESET UP/DOWN buttons Press Press Leave for 1. 5 sec. ¼ Preset tuning by recalling a preset station Select the preset no. of the desired station in the same manner as when presetting a station in the memory. DELETING THE CONTENTS OF THE PRESET MEMORY TUNING UP ( ) / DOWN ( ) BUTTON Every time the UP or DOWN side of the TUNING button is pressed, the receiving frequency varies in the upward or downward direction, in the steps of 50 kHz in FM band or 9 kHz in AM band. When the button is held depressed for more than 0. 5 seconds, the receiving frequency varies continuously in the above-mentioned steps until a station is received. Press or hold the button until the desired frequency is displayed on the digital frequency indicator. 5 sec. ), turn the GYRO CONTROL ring to set the present number to "00". The preset number and "CLEAR" indicator will flash for approx. Station names memorized for the preset station will also be deleted at the same time. PRESET UP ( ) / DOWN ( ) BUTTON Every time the UP or DOWN side of the PRESET button is pressed, the preset number will advanced one step in the upward or downward direction. This button is also used as the CURSOR button in the station name input mode. PRESET MEMORY ON THE REMOTE CONTROL UNIT This unit is equipped with the one-touch preset tuning system which is particularly convenient when there is a large number of receivable stations. The preset tuning system allows up to 60 stations on FM and AM to be preset in a random order. 7 FRANÇAIS DISPLAY button BAND button ENGLISH BUTONNS AND OPERATION OF THE REMOTE CONTROL UNIT HOW TO PRESET A FREQUENCY IN THE MEMORY 1. [. . . ] Check whether noise is produced by other audio/video components, electrical appliances or fluorescent lamps in your room. 4. To improve the AM reception, try using an external antenna. 10 TECHNICAL SPECIFICATIONS ENGLISH FRANÇAIS FM Tuner section Mono usable sensitivity . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1. 0 V Sensitivity fo 50dB quieting Mono . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1. 3 V Stereo . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]