User manual MARANTZ SR7200

[. . . ] R Model SR7200 User Guide AV Surround Receiver CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK) NO USER-SERVICEABLE PARTS INSIDE REFER SERVICING TO QUALIFIED SERVICE PERSONNEL The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of suffi-cient magnitude to constitute a risk of electric shock to persons. The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. WARNING TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE SLOT, FULLY INSERT. ATTENTION: POUR ÉVITER LES CHOCS ÉLECTRIQUES, INTRODUIRE LA LAME LA PLUS LARGE DE LA FICHE DANS LA BORNE CORRESPONDANTE DE LA PRISE ET POUSSER JUSQU'AU FOND. NOTE TO CATV SYSTEM INSTALLER: This reminder is provided to call the CATV (Cable-TV) system installer's attention to Article 820-40 of the NEC, that provides guidelines for proper grounding and, in particular, specified that the cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as practical. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. [. . . ] 4. 5. 6. Press the MULTI ROOM button !1, the POWER ON button, or select the desired source on multi room remote control unit from the MULTI ROOM. Any of these operations will put the SR7200 into multi room mode and "MULTI ROOM" indicator will light and OSD system for the TV in the multi room will be shown. Press the VOL. UP or VOL. DOWN button on the multi room remote control unit to set the desired sound volume. In multi room mode, the multi room remote control unit can be used in the multi room to operate the following functions. You can select a tuner preset channel and tuning up or down, and direct selection. And you can control the CD player, DVD player VCR and tape deck connected to the SR7200. Additionally, SLEEP timer function for multi room is available from second zone, by the same way as setting the sleep timer for main room. The status of the main room setting can be monitored from the second zone with the OSD. Caution: If the main room and the secondary room are listening to the same source, the main room will have priority over controlling that source. For example, you cannot change the frequency or preset of the Tuner from a remote location if the main room is also listening to that source. 14 The on-screen display, which can be activated by the Main unit or remote, appears on the TV screen to show the current setting status of the SR7200. 1. GENERAL INFORMATION When the OSD button /7 is pressed, the current setting are displayed on the TV monitor. This display disappears automatically in about 5 seconds after the button is pressed. AUTO DTS DOLBY PL II MOVIE DOLBY PL II MUSIC STEREO 6CH STEREO VIRTUAL MATRIX STADIUM HALL DOLBY PRO LOGIC 6. 1CH SURROUND CS 5. 1 MOVIE q VIDEO SOURCE: Displays the current video source being selected with the function selector TV, DVD, VCR1, DSS or AUX. w AUDIO SOURCE: Displays the current audio source being selected with the function selector FM, AM, CD, TAPE, CD-R, TV, DVD, VCR1, DSS or AUX. 3. MASTER VOLUME CONTROL e DIGITAL INPUT: Displays the digital input that you are using DIG-1, DIG-2, DIG-3, DIG-4 or DIG-5. r SURROUND MODE: Displays the current surround mode AUTO, STEREO, 6CH STEREO, VIRTUAL, MATRIX, STADIUM, HALL, MOVIE, CS5. 1, 6. 1 CH SURR, PLO LOGIC, PLII MUSIC, PLII MOVIE, DTS t MULTI ROOM Displays the current status of the Multi Room function, ON or OFF. Note: The On-Screen Display signals for the main room can be output from the TV MONI composite video (RCA) output and the TV MONI, S-Video and TV MONI component video output jacks. With some video equipment or software, the On-Screen Display characters may be distorted due to noise or tracking adjustment error. Displayed when the MASTER volume is varied or a button of the remote control unit is pressed. 4. MUTE When the MUTE button !2//3 is pressed, "MUTE ON" will be shown on screen. Pressing MUTE button !2//3 again will show "MUTE OFF" on screen, and return to the previous volume level. 15 ENGLISH ON SCREEN DISPLAY INFOMATION 2. FUCTION SELECT & SURROUND MODE When a function selector button or surround mode button is pressed VIDEO: Displays the current video source. When TV, DSS, DVD, VCR1 or AUX is selected with the function selector, both AUDIO and VIDEO shows the same name. SURR-MODE: Displays the current Surround mode as follows; 5. SLEEP TIMER When the SLEEP button o is pressed, the setting on or off and the remaining time of the sleep timer function are displayed. [. . . ] Box 5604, Nicosia, Cyprus Sokolska 41, 67902 Rajecko, OKR, Blansko, Czech Republic Dali Allé 1, 9610 Noerager, Denmark P. O. Doki, Cairo, Egypt Ehte 4, 90503 Haapsalu, Estonia ul. Cedomir Kantargiev 21a, Skopje, Former Yugoslavian Republic of Macedonija Uudenmaankatu 4-6, Helsinki SF-00120, Finland A division of Marantz Europe B. V. , P. O. Box 301, 92 156 Suresnes Cedex, France Hakenbusch 3, 49078 Osnabrück, Germany 188, Hippocratous Street, 11471 Athens, Greece Building SFF-2, P. O. Box 80002, 5600 JB Eindhoven, The Netherlands Unit 1706, Metroplaza II, 223 Hing Fong Road, Kwai Fong, N. T. , Kowloon, Hong Kong Terez Krt. 31, 1067 Budapest, Hungary Armula 38, 108 Reykjavik, Iceland 8, Punam Co-op. Society 29/30 Road#5, Union Park MUMBAI 400052, India 5th floor no 878 Philips Building Enghelab ave, P. O. [. . . ]