User manual MARANTZ RC 5500SR

[. . . ] 5J/PPC CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK) NO USER-SERVICEABLE PARTS INSIDE REFER SERVICING TO QUALIFIED SERVICE PERSONNEL The lightning flash with arrowhead symbol within an equilateral triangle is intended to alert the user to the presence of uninsulated “dangerous voltage” within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the product. IMPORTANT SAFETY INSTRUCTIONS READ BEFORE OPERATING EQUIPMENT This product was designed and manufactured to meet strict quality and safety standards. There are, however, some installation and operation precautions which you should be particularly aware of. [. . . ] € • You can use surround back speaker terminals as multi room speaker terminals when you use no surround back speaker. Note: • If “NONE” is selected for the Surround L/R setting, then this setting is not available. Select “INPUT SETUP” in SETUP MAIN MENU with or cursor button, and press the ENTER button. 1 CD T APE CD - R I NPUT SE TUP : D4 - AT : ANA : D1 - AT TV DVD V CR 1 DSS : ANA : D3 - AT : ANA : D2 - AT 2-1 SPEAKERS SIZE When setting the speaker size in the SPEAKER SIZE sub-menu, use the guidelines given below. LARGE: The complete frequency range for the channel you are setting will be output from the speaker. If the Subwoofer is set to “NONE” and the front speakers are set to “LARGE, ” then the sound will be output from both the left and right speakers. B ACK S I Z E : SMA L L L P F / HP F : 1 0 0 HZ BASS M I X : BO T H MA I N NE X T EX I T MA I N COMP 1 : DVD COMP 2 : DSS EX I T LPF/HPF When you use a subwoofer, you can select the cutoff frequency for the small speakers used. Select one of the crossover frequency levels according to the size of the small speaker connected. 80Hz: Select this when the bass speaker is about 12 cm (4 3/4 inches). 100Hz: Select this when the bass speaker is about 10 cm (3 15/16 inches). 120Hz: Select this when the bass speaker is about 8 cm (3 3/16 inches). Notes: • Use the above comments as reference when adjusting. BASS MIX • The bass mix setting is only valid when “LARGE” is set for the front speakers and “YES” is set for the subwoofer during stereo playback . This setting has effect only during playback of PCM or analog stereo sources. €¢ When “BOTH” is selected, the low frequencies will be played through the main L&R, as well as the sub woofer. In this playback mode, the low frequency range expand more uniformly through the room, but depending on the size and shape of the room, interference may result in a decrease of the actual volume of the low frequency range. €¢ By selecting “MIX”, the low frequencies will play through the main L&R ONLY. Note: • LFE signals during playback of Dolby Digital or DTS, will be played through the sub woofer. Select “Dx-AT” for input sources, for automatic detection of the digital input signal condition. If there is not a digital signal present, but there is an analog signal present, the analog signal will be played. select “Dig x” , when only a digital signal will be used. Select “ANA” for input sources for which no digital input jacks are used. [. . . ] €¢ MULTI ROOM SPEAKER output terminals can be used when the SURROUND BACK SPEAKER is set NONE in SPEAKER SETUP menu. Back Speakers are in use” is displayed by pressing the MULTI SPEAKER button when the SURROUND BACK SPEAKER is set except NONE in SPEAKER SETUP menu. (See SPEAKER SETUP, page 18) • Multi room operations cannot be performed from the remote controller. CAUSE REMEDY In case of trouble, check the following before calling for service: 1. [. . . ]