User manual MARANTZ PM11S3

[. . . ] Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. Do not defeat the safety purpose of the polarized or grounding-type plug. If the provided plug does not fi t into your outlet, consult an electrician for replacement of the obsolete outlet. Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the point where they exit from the apparatus. [. . . ] To INPUT 2 Use or INPUTSELECTOR on the unit df on the remote control to select the source. € The input source changes as follows with each press of the button: CD BALANCED PHONO LINE-1 LINE-2 RECORDER1 RECORDER2 Basic connections Basic operation Turning the power standby Press X AMP. Advanced connections • Press X AMP to turn on power from standby mode. € You can also turn on power by using either INPUT SELECTOR on this unit from standby mode. NOTE Power continues to be supplied to some of the circuitry even when the power is in the standby mode. When leaving home for long periods of time or when going on vacation, either press X ON/OFF to turn off the power, or unplug the power cord from the power outlet. Indd 11 2012/05/21 19:03:31 ENGLISH Starting playback Adjusting the levels nnLeft and right channel balance The volume level of the left and right channels can be trimmed in 0. When the unit is shipped from the factory, the volume level is set to 0. Adjusting the tone nnLow frequency range The low frequency range can be trimmed in 2 dB steps across a –8 – +8 dB range. Before making this adjustment, press TONE on the unit or the remote control to set the tone control to on. The high frequency range can be trimmed in 2 dB steps across a –8 – +8 dB range. Before making this adjustment, press TONE on the unit or the remote control to set the tone control to on. € If not operated for 15 seconds, the current setting is saved and the display returns to normal. € If not operated for 15 seconds, the current setting is saved and the display returns to normal. NOTE Before making the adjustment for level and tone, press MODE/ AMP to set its control mode to amplifier. Indd 12 2012/05/21 19:03:32 ENGLISH Starting playback Muting the sound Sound can be muted temporarily. € When using headphones, turn off the speaker output using SPEAKERS A/SPEAKERS B. € To prevent hearing loss, do not raise the volume level excessively when using headphones. Switching the illumination lamp setting The illumination lamps on the both sides of the unit main panel can be turned on or off. Basic connections “ATT” appears on the display and the sound is muted. On (Factory default) Basic operation • To restore the sound, press the button again. Off nnHow to Set Attenuation Level • Attenuation level can only be set using ATT on the unit. [. . . ] For details on ID number setting, see “How to set ID number for F. Nn Is the unit being operated as described in the owner’s manual?If this unit does not operate properly, check the items listed in the table below. In that case, disconnect the power immediately and contact your retail outlet. [. . . ]