User manual MARANTZ NR1604

[. . . ] Basic instructions Advanced instructions Information AV Surround Receiver NR1604 Owner?s Manual DVD n SAFETY PRECAUTIONS RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated ?dangerous voltage?within the product?s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. 1. 2. 3. 4. 5. 6. 7. 8. WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. Read these instructions. [. . . ] Remembering set details (Backup). Panel lock function To prevent accidental operation of this unit, you can disable operation of the buttons on the front panel. Basic instructions nnCanceling the Panel lock function while 1 Press Xwith theyou press and hold DISPLAY and M-DAX unit in standby mode. or ZONE2 SOURCE to select (z The currently set mode. ) INTERNET RADIO X ON/STANDBY STATUS VOLUME ZONE2 SOURCE Advanced instructions 3 Press STATUS to enter the setting. The Panel lock function is canceled. INTERNET RADIO DISPLAY M-DAX DISPLAY ZONE2 SOURCE nnRemembering set details (Backup) Set the unit in the state you want remembering, and press and hold INTERNET RADIO and ZONE2 SOURCE for at least 3 seconds. Even when the Panel lock function is set, you can operate the unit using the remote control unit. nnDisabling all key button operations while 1 Press Xwith theyou press and hold DISPLAY and M-DAX unit in standby mode. 3 Press STATUS to enter the setting. All button operations except X are disabled. ?MEMORY SAVING?is shown in the display, and the setting details are remembered. Information NOTE ? The volume is not remembered. ? If remembered details are overwritten, the previously remembered contents are deleted. nnRecalling remembered details (Recovery) Press and hold DISPLAY and INTERNET RADIO together for at least 3 seconds. ?MEMORY LOAD?is shown in the display, and the remembered details are recalled. nnDisabling all button operations except VOLUME while 1 Press Xwith theyou press and hold DISPLAY and M-DAX unit in standby mode. Press INTERNET 2 ?FP LOCK On?. RADIO or ZONE2 SOURCE to select 3 Press STATUS to enter the setting. All button operations except X and VOLUME are disabled. NOTE ? If there is no remembered data, ?NO BACKUP?? As the volume cannot be recalled, it returns to the factory setting volume. DVD 99 Remote lock function ? When not connecting an IR receiver, disable the Remote lock function. When the function is enabled, you can not perform operations with the remote control unit. ? By default, this function is disabled. Various memory functions nnEnabling the remote sensor function the main unit is in standby X 1 When holding down DISPLAY and mode, pressthe while M-DAX on main unit. or ZONE2 SOURCE to select (z The currently set mode. ) Basic instructions Personal memory plus function This function sets the settings (input mode, sound mode, HDMI output mode, MultEQ, Dynamic EQ, audio delay etc. ) last selected for the individual input sources. X ON/STANDBY INTERNET RADIO STATUS The surround parameters, tone control settings and the volumes of the different speakers are stored for the individual sound modes. Advanced instructions 3 Press STATUS to enter the setting. M-DAX DISPLAY ZONE2 SOURCE The infrared light receiving function on the main unit is enabled. Last function memory This function stores the settings which were made before going into the standby mode. When the power is turned back on, the settings are restored. nnDisabling the sensor function of the remote control unit the main unit is in standby X 1 When holding down DISPLAY and mode, pressthe while M-DAX on main unit. Press INTERNET 2 ?RC LOCK On?. RADIO or ZONE2 SOURCE to select 3 Press STATUS to enter the setting. The infrared light receiving function is disabled. Information DVD 100 Playback in ZONE2 (Separate room) ? You can operate this unit so as to enjoy audio in a room (ZONE2) other than the MAIN ZONE (room where the unit is located). ? You can simultaneously play back the same source in both the MAIN ZONE and ZONE2. You can also play back separate sources in the MAIN ZONE and ZONE2. Basic instructions ZONE2 to switch 1 Press to the ZONE2. the zone mode ZONE2 lights. Playback Adjusting the volume Use VOLUME df to adjust the volume. Audio output Zone playback by speaker output ? Set the ?Assign Mode?(vpage 124) setting to ?ZONE2?, and outputs ZONE2 audio from SURROUND BACK speaker terminals (The default setting is ?ZONE2?). (vpage 124) setting to ?ZONE2?, the main zone home theater system can play back up to 5. 1 channels. Even if you play back audio recorded in 6. 1 or 7. 1 channels, this unit automatically downmixes the audio to 5. 1 channels. 2 Press POWER X to turn on the ZONE2 power. The lights. Advanced instructions indicator on the display GAdjustable rangeH 0 ?(vpage 132) is set to ?70 (?10dB)?. ? Also press input source select button when in standby mode, the power turns on. ? Power in ZONE2 can be turned on or off by pressing ZONE2 ON/OFF on the main unit. Input source select buttons nnConnecting and setting the speakers ?Assign Mode?setting (vpage124) and audio signals output Connecting the speakers ZONE2 3 Press the input source select button to select the input source to be played. The audio signal of the selected source is output to ZONE2. [. . . ] IN NO EVENT SHALL THE FOUNDATION OR CONTRIBUTORS BE LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS INTERRUPTION) HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGE. Information nn libvorbis nn Mersenne Twister http://www. math. sci. hiroshima-u. ac. jp/~m-mat/MT/ MT2002/CODES/mt19937ar. c Copyright (C) 1997 - 2002, Makoto Matsumoto and Takuji Nishimura, All rights reserved. Redistribution and use in source and binary forms, with or without modification, are permitted provided that the following conditions are met: 1. edistributions of source code must retain the R above copyright notice, this list of conditions and the following disclaimer. 2.  edistributions in binary form must reproduce R the above copyright notice, this list of conditions and the following disclaimer in the documentation and/or other materials provided with the distribution. DVD LICENSE 3.  he names of its contributors may not be used T to endorse or promote products derived from this software without specific prior written permission. THIS SOFTWARE IS PROVIDED BY THE COPYRIGHT HOLDERS AND CONTRIBUTORS ?AS IS?AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE ARE DISCLAIMED. [. . . ]