User manual MARANTZ MOUNT 12 INSTALL GUIDE

[. . . ] MOUNT12 INSTALLATION INSTRUCTIONS Step 1 Invert the projector and place it on a soft and flat surface. [. . . ] Raise the projector with the mounting bracket attached and slip though the hinge pin slots openings on the bracket into the base box. Install the two (2) angle locking screws (I) adjust the angle, lock it, and then tighten the hinge pin screws. See Figure 2 (Refer to its Installation Instructions) Step 4 Check all the hardware for proper tightness and security. PORTABLE PROJECTORS (1) Remove the knurl knob screw and hold the projector with two hands. Reverse the process for quick reinstall. Step 2 Install the base box securely to the ceiling structure in accordance with proper commercial standards. Use (commercially available) suitable hardware depending on the installation requirements. (2) (3) Step 5 Raise the projector with the mounting bracket (E) and slip through the hinge pin slot openings on the bracket into the base box (H). Loosely install the two (2) hinge pin screws (J), conical spacers (L) and flat washers (K) and the angle locking screws (I). Do not over tighten See Figure 3 The ceiling should be capable of supporting a weight of at least five (5) times the projector(s) or monitor(s)weight. [. . . ] Suspension Adapter Ajustable Pins (2ea) For further information or ordering assistance contact us at the phone/address number shown on the front of this page. Check all hardware for proper tighten and security. -_LA 061801_- [. . . ]