User manual MARANTZ IS301E

[. . . ] 16 2:38:52 PM CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK) NO USER-SERVICEABLE PARTS INSIDE REFER SERVICING TO QUALIFIED SERVICE PERSONNEL The lightning flash with arrowhead symbol within an equilateral triangle is intended to alert the user to the presence of uninsulated “dangerous voltage” within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the product. IMPORTANT SAFETY INSTRUCTIONS READ BEFORE OPERATING EQUIPMENT This product was designed and manufactured to meet strict quality and safety standards. There are, however, some installation and operation precautions which you should be particularly aware of. [. . . ] The unit will automatically start preparing for wireless audio playback. When the PAIRING indicator starts flashing in blue at intervals of 5 seconds, preparation for audio playback is completed. Notes • Even if wireless connection is interrupted for some reason, such as radio wave interference or power failure, reconnection will automatically be performed. € If reconnection is not possible, the PAIRING indicator will light in red. In such a case, press the PAIRING button of the handset twice to disconnect then press the same button again so that the PAIRING indicator lights in red. When the PAIRING indicator starts flashing in blue at intervals of 5 seconds, preparation for reconnection is completed. USB • NEVER insert the iPod into the handset with its protective case attached. € Do not use other accessories, such as an FM transmitter or microphone, with the handset. € Marantz accepts no responsibility whatsoever for any loss or damage of iPod data resulting from the use of an iPod product connected with this unit. IN A CASE WHERE THE IPOD AND HANDSET ARE USED DETACHED FROM THE BASE UNIT Depending on the type of iPod, the handset may not enter Wireless mode when the iPod is started. In such a case, detach the iPod from the handset with the iPod’s power on then reconnect it to the handset. TROUBLESHOOTING ADVANCED OPERATIONS M EN BASIC OPERATIONS NAMES AND FUNCTIONS BASIC OPERATIONS N N E M U ENGLISH BASIC OPERATIONS NAMES AND FUNCTIONS BASIC BASIC OPERATIONS OPERATIONS ADVANCED OPERATIONS TROUBLESHOOTING OTHERS IS-LINK (WIRED) CONNECTIONS WHAT ARE AVAILABLE WHEN IS-LINK CONNECTIONS ARE USED • • • • Audio and video playback Remote operations of a Marantz amplifier or receiver, using the AMP control buttons on the handset Remote control of a Marantz amplifier, using the supplied remote controller Use of the base unit as an infrared signal receiver for controlling a Marantz product ME NU B S U Handset BEFORE CONNECTION Notes • What are NOT available when IS-LINK connections are made are as follows: • Video playback of an iPod when the iPod and the handset are detached from the base unit • During IS-LINK connection, power is supplied to the base unit from the extender. Therefore, it is not necessary to connect the AC adaptor to the base unit. Set the Video selection switch of the base unit according to the video output signal to be used. € If the Video selection switch is switched during video playback, the output signal may not be switched, depending on the type of iPods being connected. In such a case, go back to the MENU screen then restart video playback. Connect the AUDIO OUT terminals of the extender with the line input terminals of an amplifier/ receiver, via the supplied AV cable. Connect the video input terminal of an amplifier/receiver/TV to one of the VIDEO OUT terminals (VIDEO/S-VIDEO/COMPONENT) of the extender, using an appropriate video cable. The S-VIDEO and component video cables are not supplied with this unit. Note NEVER connect different video cables simultaneously, as this may result in disturbed video signals or a failure. Extender If you wish to remotely control the connected equipment using the Marantz REMOTE CONTROL terminals, connect the REMOTE CONTROL terminals of the connected equipment and the extender with the supplied remote cable. Connect the supplied AC adaptor to the AC adaptor terminal of the extender. [. . . ] If checking the following items does not resolve your problem, please contact the retail store where you purchased your product, your nearest Marantz authorized dealer or the Marantz Service Center in your country. Symptom Possible cause Resolution CLEANING OF EQUIPMENT EXTERNAL SURFACES The exterior finish of your unit will last indefinitely with proper care and cleaning, Never use scouring pads, steel wool, scourging powders or harsh chemical agents (e. , lye solution), alcohol, thinner, benzine, insecticide or other volatile substances as these will mar the finish of the equipment. If the equipment get dirty, wipe the external surfaces with a soft, lint-free cloth. [. . . ]