User manual MARANTZ AS6150 INSTALL GUIDE

[. . . ] * This plasma display stand is designed specifically for use with MARANTZ 61-inch plasma displays. Special skills are required to install the Plasma Display. Attention: Sales Agents and Technicians To ensure the user's safety, be sure to select a place sufficiently strong to bear the weight of the Plasma Display and the different units. Be careful not to lose removed screws, etc. Parts Included * Feet (2) * Bar (1) Stand assembly screws M4 x 10 (8) Screwdriver Display mounting screws M6 x50 (4) * Handling instructions (these instructions) Specifications Model: AS6150 External dimensions: (W) 1125 x (H) 205 x (D) 430 mm (W) 44. 3 x (H) 8. 1 x (D) 16. 9 inchs Weight: 6. 5 kg 14. 3 lbs Operating conditions: Temperature 0° to 40°C / 32°F to 104°F Storage conditions: Temperature -10° to 50°C / 14°F to 122°F Humidity 20%~80% Humidity 10%~90% 41AW851010 Always Heed the Following Before Use. . . Symbols Various symbols are used in this Handling Instructions for the safe and proper use of the product as well as preventing any injury or damage to persons or property. [. . . ] If the ventilation holes are covered, the heat will build up inside, and this could lead to fire. For example, do not install the Plasma Display in narrow spaces where ventilation is poor, do not place covers over it, etc. - Do not install the Plasma Display near air conditioner air outlets or in places where vibrations are strong. - Do not install the Plasma Display in humid or dusty places or places exposed to soot or vapor (such as in kitchens, near humidifiers, etc. ). - When installing the Plasma Display, leave sufficient space around it, as shown in the diagram. Failure to do so could cause heat to build up inside, leading to fire. 50mm/1. 97inch 50mm/1. 97inch 50mm/ 1. 97inch 50mm/ 1. 97inch 50mm wall - Hold the Plasma Display securely when mounting the units on it. Failure to do so could cause the Plasma Display to fall, resulting in injury. - When installing the Plasma Display on a stand with casters, be sure to block the casters. If the stand should move, the Plasma Display could fall, resulting in injury. - The Plasma Display is heavy, so be sure to install in a stable place and take measures to prevent it from tipping over and causing injury. It should be unpacked and moved by a minimum of two people, holding it at the top and bottom. Failure to do so could cause the Plasma Display to fall, resulting in injury. NOTES Avoid dusty or humid rooms and rooms filled with soot or cigarette smoke. The Plasma Display's screen could get dirty, resulting in poor picture quality. Avoid places where the screen is exposed to direct sunlight or strong artificial light. If surrounding light should shine on the screen, the screen will appear white and be hard to see. Additional fall prevention measures - Either use the tip prevention fitting included with the display to fix the plasma display to a wall, pillar or other strong place or use the holes on the back on the stand to fix to a table, etc. . (Do no use with the separately sold ceiling mount unit or wall mount unit. ) - Pay attention to the rope when moving the Plasma Display. - The screws for fastening the display to the wall, a pillar or a stand are not included. Please obtain screws suited for the surface on which the display is to be mounted. 3 Assembling the stand Preparations····Unpack the plasma display. 1. [. . . ] Insert the plasma display into the stand. Check that the stand and plasma display are facing the proper direction, then insert the plasma display into the stand. This procedure should be done by at least three persons, since the plasma display is heavy and has a high center of gravity. Hold the bottom and the grips on the back of the plasma display and support the top when inserting the plasma display into the stand. [. . . ]