User manual MALAGUTI FIREFOX F15

[. . . ] Indicates that the operation must be repeated on the opposite side of the unit or component. Situations entailing the risk of personal injury to maintenance or repair mechanics, other workshop personnel or third parties, or damage to environment, vehicle or equipment. Indicates that negative pole is to be disconnected from the battery before performing the operation. Indicates information which may be obtained by referring to said manual. [. . . ] Horizontally), 2 etcly Balancing Note: Note Wheel balancing must always be made with the tyre installed. Slowly turn the wheel several turns marking on the tire the point in which it stops with a felt pen or a chalk. slowly · The wheel is out of balance if it always comes to a stop in the same point without any hint of back turning. This point, The means that the wheel is heavier in this point, which always comes to be facing downwards. Pull the rear brake lever and check that the brake is applied after a free play of the lever of about 10 mm ( . Turn the wheel by hand and pull the brake lever several times to check for proper free play, braking efficiency and free wheel rotation after the lever has been released. 15 and that its thread is not completely engaged 15) A (which otherwise indicates that shoes are completely worn. worn) Disc brake · The lever which operates the hydraulic braking system must always be endowed with a certain free play which, ee however, must not be excessive. Remove the rear wheel (t aking care to first allow the muffler to cool down) following the instructions contained in the specific service manual for each model. Grasp the two segments of the shoe ring (1 - F 18) with both hands from the inside, pulling them outwards so as to 1 . This operation must be performed with utmost care as the fingers may be crushed by the strong resistance of the springs. Loosen the nut (3 - F 17) and remove the lever (4), paying utmost attention to the spiral spring to which it is 3 . pin) · Thoroughly clean and grease ( only the central part of the pin . Take care not to smudge grease on to the shoes or surrounding areas, especially the brake linings. When reinstalling, check that the pin/cam assembly fits freely and smoothly into its seat. Never use a hammer o r any other similar tool to reinstall the pin/cam assembly. During pin/cam maintenance and in any case during periodical inspection after prescribed mileage (see periodical maintenance schedule) always check shoes for wear, bearing in mind that the pad must never be less than 2 mm schedule), t i k (F. Carefully clean the drum surface which comes into contact with the wheel and check that there are no appreciable grooves or scratches, otherwise grind the drum smooth. Note: Note All Malaguti motor-bikes are equipped with front disc brakes and some models also with rear disc brakes. For visual inspection of oil level and removal of any parts in order to gain access to the oil reservoir, refer to the instructions in the specific manual for each model. The level is correct when the oil is 3 mm from the lower edge of the inspection window (2). Never operate the brake lever when the screws are loosened or the cover is removed from the reservoir. [. . . ] Operate the installing tool until the crankshaft bottoms against the bearing. Note: hold the connecting rod at top dead center with one hand while turning the nut of the Installing Tool with the other. Operate the Installing tool until the crankcase (right) bottoms against the crankcase (left). Note: tighten the crankcase holding screws in stage, using a crisscross pattern, in numerical order. [. . . ]