User manual MAKITA UH550D

[. . . ] String Press Chip receiver Nut Shear blade Branch catcher Hooks Fit the hooks into groove 31. Grooves Press the levers on both sides Unlock the hooks Blade cover Screws Under cover Plate Crank Oval hole of shear blade Limit mark Holder cap cover Screwdriver Brush holder cap SPECIFICATIONS Model Blade length Strokes per minute (min-1) Overall length Net weight Rated voltage 1, 070 mm 5. 36V UH550D BUH650 650 mm 1, 000 - 1, 800 1, 154 mm UH650D • Due to our continuing program of research and development, the specifications herein are subject to change without notice. €¢ Specifications and battery cartridge may differ from country to country. [. . . ] €¢ Low battery voltage: The remaining battery capacity is too low and the tool will not operate. 2) The handle can be rotated to either 90° left or right and mounted either 45° or 90° position to fit your work needs. First, pull the knob and rotate the handle clockwise or counterclockwise in the direction of arrow as shown in the figure. CAUTION: • Always make sure that the handle is locked in the desired position before operation. Switch action CAUTION: • Before inserting the battery cartridge into the tool, always check to see that the switch trigger actuates properly and returns to the “OFF” position when released. 3) For your safety, this tool is equipped with a dual switching system. The sequence of switching is unimportant as the tool only starts when both switches are activated. Battery remaining capacity indicator (only for models with Battery BL3622A) Battery BL3622A is equipped with the battery remaining capacity indicator. 4) The strokes per minute can be adjusted just by turning the adjusting dial. 011713 may accidentally fall out of the tool, causing injury to you or someone around you. If the adapter does not slide in easily, it is not being inserted correctly. €¢ The way of removing or installing a battery cartridge from or on the battery adapter is the same as that of removing or installing it from or on the tools. €¢ Press down the hook securely as far as it will go when the battery adapter is hooked on the waist belt and similar objects. Arm cord hook (Accessory) CAUTION: • Do not attach the holder of arm cord hook to other than the extension cord. Using the arm cord hook helps to minimize a risk of cutting off the extension cord unexpectedly caused by the loose extension cord. 8) Attach firmly the arm cord hook band placing around your arm and pass the extension cord through the holder. NOTE: • Do not pass the extension cord through the band. €¢ When only the lowermost indicator lamp (next to the “E”) blinks, or when none of the indicator lamps light, the battery capacity has run out, so the tool does not operate. In these cases, charge the battery or replace the empty battery with a fully charged one. €¢ When two or more indicator lamps do not light even after charging is complete, the battery has reached the end of its service life. €¢ When the upper two and lower two indicator lamps light alternately, the battery may have malfunctioned. NOTE: • The indicated capacity may be lower than the actual level during use or immediately after using the tool. [. . . ] MAINTENANCE CAUTION: • Always be sure that the tool is switched off and the battery cartridge is removed before attempting to perform inspection or maintenance. Cleaning the tool Clean out the tool by wiping off dust with a dry or soapdipped rag. CAUTION: • Never use gasoline, benzine, thinner, alcohol or the like. Blade maintenance Smear the blade before and once per hour during operation using machine oil or similars. [. . . ]