User manual MAKITA TW100D

[. . . ] The proper fastening torque may differ depending upon the kind or size of the bolt. Before using battery cartridge, read all instructions and cautionary markings on (1) battery charger, (2) battery, and (3) product using battery. It may result in a risk of overheating, possible burns and even an explosion. If electrolyte gets into your eyes, rinse them out with clear water and seek medical attention right away. [. . . ] Changing the direction of rotation before the tool stops may damage the tool. ⷠWhen not operating the tool, always set the reversing switch lever to the neutral position. Always be sure that the tool is switched off and the battery cartridge is removed before adjusting or checking function on the tool. Always be sure that the tool is switched off and the battery cartridge is removed before carrying out any work on the tool. Always switch off the tool before installing or removing of the battery cartridge. ⷠTo remove the battery cartridge, withdraw it from the tool while pressing the buttons on both sides of the cartridge. ⷠTo install the battery cartridge, hold it so that the battery cartridge front shape fits to that of the battery installment opening and slip it into place. Always insert it all the way until it locks in place with a little click. If not, it may accidentally fall out of the tool, causing injury to you or someone around you. ⷠDo not use force when installing the battery cartridge. If the cartridge does not slide in easily, it is not being inserted correctly. To install the socket, push it onto the anvil of the tool until it locks into place. The proper fastening torque may differ depending upon the kind or size of the bolt, the material of the workpiece to be fastened, etc. nOTE: · When fastening screw M8 or smaller, carefully adjust pressure on the switch trigger so that the screw is not damaged. ⷠHold the tool pointed straight at the bolt or nut without applying excessive pressure on the tool. Before starting your job, always perform a test operation to determine the proper fastening time for 5 Before inserting the battery cartridge into the tool, always check to see that the switch trigger actuates properly and returns to the "OFF" position when released. Especially for the bolt smaller than M8, perform the above test operation to prevent the trouble on socket or bolt, etc. ⷠIf the tool is operated continuously until the battery cartridge has discharged, allow the tool to rest for more than 15 minutes before proceeding with a fresh battery. the fastening torque is affected by a wide variety of factors including the following. When the battery cartridge is discharged almost completely, voltage will drop and the fastening torque will be reduced. [. . . ] Be sure to close the holster securely so that it holds the tool firmly. The declared vibration emission value has been measured in accordance with the standard test method and may be used for comparing one tool with another. ⷠThe declared vibration emission value may also be used in a preliminary assessment of exposure. wARNING: · The vibration emission during actual use of the power tool can differ from the declared emission value depending on the ways in which the tool is used. [. . . ]