User manual MAKITA TM3000C

[. . . ] It is also intended for working soft wall tiles, as well as dry sanding and scraping of small surfaces. Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury. This power tool is intended to function for sawing, cutting, grinding and sanding. [. . . ] When changing the dial direction, always turn the dial moving it through each intermediate number. Constant speed control Electronic speed control for obtaining constant speed. Possible to get fine finish, because the orbital stroke rate is kept constant even under load condition. ASSEMBLY CAUTION: • Always be sure that the tool is switched off and unplugged before carrying out any work on the tool. Installing application tool upside down may damage the tool and cause serious personal injury. €¢ Install attachment tool in the correct direction according to your work. Put an application tool (optional accessory) on the tool flange so that the protrusions of the tool flange fit in the holes in the application tool and secure the application tool by tightening the bolt firmly with the hex wrench. As sanding papers have holes for dust extraction, mount a sanding paper so that the holes in a sanding paper match those in the sanding pad. Loosen and remove the application tool installation bolt using a hex wrench and then take off the application tool. When using application tools with a different type of installation section, use a correct adapter (optional accessory). WARNING: DO NOT let comfort or familiarity with product (gained from repeated use) replace strict adherence to safety rules for the subject product. MISUSE or failure to follow the safety rules stated in this instruction manual may cause serious personal injury. FUNCTIONAL DESCRIPTION WARNING: • Always be sure that the tool is switched off and unplugged before adjusting or checking function on the tool. Failure to switch off and unplug the tool may result in serious personal injury from accidental start-up. 6 OPERATION WARNING: • Before starting the tool and during operation, keep your hand and face away from the application tool. €¢ Do not apply excessive load to the tool which may cause a motor lock and stop the tool. [. . . ] 5 m/s2 Work mode: Cutting with plunge cut saw blade Vibration emission (ah): 6. 5 m/s2 Work mode: Cutting with segmental saw blade Vibration emission (ah): 3. 5 m/s2 ENG901-1 • The declared vibration emission value has been measured in accordance with the standard test method and may be used for comparing one tool with another. [. . . ]