User manual MAKITA TD101F

[. . . ] € Weight according to EPTA-Procedure 01/2003 Intended use ENE033-1 The tool is intended for screw driving in wood, metal and plastic. Power supply ENF002-1 The tool should be connected only to a power supply of the same voltage as indicated on the nameplate, and can only be operated on single-phase AC supply. [. . . ] Holding the tool Hold the tool only by the handle when performing an operation. The proper fastening torque may differ depending upon the kind or size of the screw/bolt, the material of the workpiece to be fastened, etc. The relation between fastening torque and fastening time is shown in the figures. 8 & 9) Hold the tool firmly and place the point of the driver bit in the screw head. Apply forward pressure to the tool to the extent that the bit will not slip off the screw and turn the tool on to start operation. NOTE: • Use the proper bit for the head of the screw/bolt that you wish to use. € When fastening screw M8 or smaller, carefully adjust pressure on the switch trigger so that the screw is not damaged. Before starting your job, always perform a test operation to determine the proper fastening time for your screw. The fastening torque is affected by a wide variety of factors including the following. Driver bit or socket bit Failure to use the correct size driver bit or socket bit will cause a reduction in the fastening torque. Bolt • Even though the torque coefficient and the class of bolt are the same, the proper fastening torque will differ according to the diameter of bolt. € Even though the diameters of bolts are the same, the proper fastening torque will differ according to the torque coefficient, the class of bolt and the bolt length. The manner of holding the tool or the material of driving position to be fastened will affect the torque. Operating the tool at low speed will cause a reduction in the fastening torque. [. . . ] € Screw bits • Socket bits • Bit piece • Adjustable locator with bit • Hook For European countries only Noise ENG102-1 The typical A-weighted noise level determined according to EN60745-2-2: Sound pressure level (LpA): 90 dB (A) Sound power level LWA): 101 dB (A) Uncertainty (K): 3 dB (A) Wear ear protection Vibration ENG205-1 The vibration total value (tri-axial vector sum) determined according to EN60745-2-2: Work mode: impact tightening of fasteners of the maximum capacity of the tool Vibration emission (ah): 7. 5 m/s2 EC-DECLARATION OF CONFORMITY ENH101-9 Model; TD0101, TD0101F We declare under our sole responsibility that this product is in compliance with the following standards of standardized documents; EN60745, EN55014, EN61000 in accordance with Council Directives, 2004/108/EC, 98/37/EC. [. . . ]