User manual MAKITA TD0100

[. . . ] When operating a power tool outdoors, use an extension cord suitable for outdoor use. Use of a cord suitable for outdoor use reduces the risk of electric shock. Stay alert, watch what you are doing and use common sense when operating a power tool. Do not use a power tool while you are tired or under the influence of drugs, alcohol or medication. [. . . ] An undersized cord will cause a drop in line voltage resulting in loss of power and overheating. Table 1 shows the correct size to use depending on cord length and nameplate ampere rating. DO NOT let comfort or familiarity with product (gained from repeated use) replace strict adherence to impact driver safety rules. If you use this tool unsafely or incorrectly, you can suffer serious personal injury. Hold power tool by insulated gripping surfaces, when performing an operation where the fastener may contact hidden wiring or its 3 2. Fasteners contacting a "live" wire may make exposed metal parts of the power tool "live" and could give the operator an electric shock. MISUSE or failure to follow the safety rules stated in this instruction manual may cause serious personal injury. Volts amperes hertz alternating current no load speed Class II Construction revolutions or reciprocation per minute number of blow Use the reversing switch only after the tool comes to a complete stop. Changing the direction of rotation before the tool stops may damage the tool. CAUTION: Always be sure that the tool is switched off and unplugged before adjusting or checking function on the tool. CAUTION: Always be sure that the tool is switched off and unplugged before carrying out any work on the tool. CAUTION: Before plugging in the tool, always check to see that the switch trigger actuates properly and returns to the "OFF" position when released. To install the bit, pull the sleeve in the direction of the arrow and insert the bit into the sleeve as far as it will go. To remove the bit, pull the sleeve in the direction of the arrow and pull the bit out firmly. nOTE: · If the bit is not inserted deep enough into the sleeve, the sleeve will not return to its original position and the bit will not be secured. In this case, try re-inserting the bit according to the instructions above. The proper fastening torque may differ depending upon the kind or size of the screw/bolt, the material of the workpiece to be fastened, etc. The size of wood screw which can be fastened with this tool may differ depending upon the type of material to be fastened. Holding the tool Hold the tool only by the handle when performing an operation. Apply forward pressure to the tool to the extent that the bit will not slip off the screw and turn the tool on to start operation. nOTE: · Use the proper bit for the head of the screw/bolt that you wish to use. When fastening screw M8 or smaller, carefully adjust pressure on the switch trigger so that the screw is not damaged. [. . . ] If inspection shows the trouble is caused by defective workmanship or material, Makita will repair (or at our option, replace) without charge. This Warranty does not apply where: repairs have been made or attempted by others: repairs are required because of normal wear and tear: the tool has been abused, misused or improperly maintained: alterations have been made to the tool. This Warranty gives you specific legal rights, and you may also have other rights which vary from state to state. Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to you. [. . . ]