User manual MAKITA RP0910

[. . . ] Use this Guide Rail Adaptor with MAKITA or FESTO Guide Rail after the guide rail adaptor is installed on Makita routers. [. . . ] for 3612 , 3612C , 3612BR , RP1800 , RP1801 , RP1800F , RP1801F , RP2300FC , RP2301FC · Insert Rod 12 (2 pcs) through installation holes in outer side of Guide Rail Adaptor, the tool (router) and the sub adaptor and then secure them with the clamping screws. Move the tool to your desired cutting position and then secure the tool to the Rod 12 with the clamping screws. CAUTION Always be sure that the router is switched off and unplugged before installing or removing onto/from the guide rail. Turn two screws shown in the position A to adjust the width d of the part of the guide rail adaptor for fitting onto the guide rail. CAUTION Do not position the cutting line of a router on any part of the surface of the guide rail. When cutting stepped workpiece in relation to work table surface, use one of supports to support the sub adaptor. [. . . ] Le niveau des segments à utiliser pour le support A doit être compris entre 0 et 10 mm alors que celui du support B doit être compris entre 9 et 35 mm. [. . . ]