User manual MAKITA RBC3110 DC24WA

[. . . ] MISUSE or failure to follow the safety rules stated in this instruction manual may cause serious personal injury. Always switch off the tool before installing or removing of the battery cartridge. ⷠTo remove the battery cartridge, withdraw it from the tool while pressing the buttons on both sides of the cartridge. ⷠTo install the battery cartridge, hold it so that the battery cartridge front shape fits to that of the battery installment opening and slip it into place. [. . . ] If the cartridge does not slide in easily, it is not being inserted correctly. Before using battery cartridge, read all instructions and cautionary markings on (1) battery charger, (2) battery, and (3) product using battery. It may result in a risk of overheating, possible burns and even an explosion. If electrolyte gets into your eyes, rinse them out with clear water and seek medical attention right away. Do not short the battery cartridge: (1) Do not touch the terminals with any conductive material. A battery short can cause a large current flow, overheating, possible burns and even a breakdown. Do not store the tool and battery cartridge in locations where the temperature may reach or exceed 50°C (122°F). Do not incinerate the battery cartridge even if it is severely damaged or is completely worn out. This system automatically cuts off power to the motor to extend battery life. The tool will automatically stop during operation if the tool and/or battery are placed under one of the following conditions: · overloaded: The tool is operated in a manner that causes it to draw an abnormally high current. In this situation, release the trigger switch on the tool and stop the application that caused the tool to become overloaded. nOTE: · If you remove the saw blade without rotating the blade clamp sleeve fully, the sleeve may not be fixed. In this case, rotate the blade clamp sleeve fully, then make the sleeve fixed at the released position. When installing a jig saw blade, loosen the bolt only threequarter to one turn from the fully tightened position. If the bolt is loosened too much, it may difficult to secure the blade straight. In this case, fully tighten the bolt without inserting the blade and loosen it three-quarter to one turn again. 7 & 8) You can use both jig saw blades (B type) and recipro saw blades according to your work. Insert the saw blade straight into the blade clamp and tighten it by hex wrench. Pull the saw blade lightly to make sure that the saw blade does not fall off during operation. To remove the saw blade, follow the installation procedure in reverse. Always be sure that the tool is switched off and the battery cartridge is removed before attempting to perform inspection or maintenance. To maintain product SAFETY and RELIABILITY, repairs, any other maintenance or adjustment should be performed by Makita Authorized Service Centers, always using Makita replacement parts. [. . . ] If you need any assistance for more details regarding these accessories, ask your local Makita Service Center. Some items in the list may be included in the tool package as standard accessories. Noise ENG905-1 The typical A-weighted noise level determined according to EN60745: When not in use, store the hex wrench. It is fixed by two projections as shown in the figure to keep it from being lost. [. . . ]