User manual MAKITA PM4601S

[. . . ] When repairing, please picks up the spark plug, then repairs it according to the operational manual. preparation • While mowing , always wear substantial footwear and long trousers. € Thoroughly inspect the area where the equipment is to be used and remove all objects which can be thrown by the machine. Never remove the cap of the fuel tank or add petrol while the engine is running or when the engine is hot; - if petrol is spilled, do not attempt to start the engine but move the machine away from the area of spillage and avoid creating any source of ignition until petrol vapors have dissipated; - replace all fuel tank and container caps securely. [. . . ] Note: During operation, when the stop control handle is released, the engine will stop and thus stopping the lawn mower from operating. 8-4 TO STOP ENGINE CAUTION: The blade continues to rotate for a few seconds after the engine is shut off. Disconnect and ground the spark plug wire as instructed in the separate engine manual to prevent accidental starting while equipment is unattended. Refuel outdoors only, before starting the engine and do not smoke while refueling or handling fuel. Never remove the cap of the fuel tank or add petrol while the engine is running or when the engine is hot. If petrol is spilled, do not attempt to start the engine but move the machine away from the area of spillage and avoid creating any source of ignition until petrol vapors have dissipated. Before tipping the lawn mower to maintain the blade or drain oil, remove fuel from tank. 8-5 CONNECTION FOR AUTO MOVE For PM-4601 S Grip the Self-drive control handle, the lawn mower will move forward automatically with about 1 m/s, release the self-drive handle, the lawn mower will stop move. For PM-4601 S3 The mower is equipped with a speed adjusting system which can adjust 3 speeds from 3. Release the Self-drive control handle until the lawn mower doesn’t go forward. 21) WARNING: Never fill fuel tank indoors, with engine running or until the engine has been allowed to cool for at least 15 minutes after running. When starting cool engine, turn engine speed lever to “ ” position. When starting warm engine and Operating, turn engine speed lever to “ ” position. Standing behind the unit, grasp the stop control handle and hold it against the upper handle as shown in Fig. Start the engine carefully according to instructions and with feet well away from the blade. Do not start the engine when standing in front of the discharge opening. CAUTION: Your mower is designed to cut normal residential grass of a height no more than 250 mm. Debris may build up on the mower deck or contact the engine exhaust presenting a potential fire hazard. Be sure that the lawn is clear of stones, sticks, wire or other foreign objects which could be accidentally thrown out by the mower in any direction and cause serious personal injury to the operator and others as well as damage to property and surrounding objects. For effective mulching do not cut wet grass because it tends to stick to the underside of the deck preventing proper mulching of the grass clippings. Ground speed will need to be adjusted so the clippings can be dispersed evenly into the lawn. For especially heavy cutting in thick grass it may be necessary to use one of the slowest speeds in order to get a clean well mulched cut. [. . . ] TROUBLE SHOOTING PROBLEM PROBABLE CAUSE Throttle chock not in the correct position for the prevailing conditions. Remove air cleaner element and pull starter rope continuously until carburetor clears itself and install air cleaner element. Remover any debris from slots in shroud, blower housing, air passages. Conforms to the following European Directives: 2006/42/EC, 2004/108/EC, 2000/14/EC & 2005/88/EC And are manufactured in accordance with the following standards or standardised documents: EN836, EN ISO14982 The technical documentation is on file at: Dolmar GmbH, Jenfelder Straße 38, Abteilung FZ, D-22045 Hamburg The conformity assessment procedure required by Directive 2000/14/EC was in Accordance with annex VI. [. . . ]