User manual MAKITA PC7612V

[. . . ] γιών Important: Read this instruction manual carefully before putting the Power Cutter into operation and strictly observe the safety regulations!We are confident that you will be satisfied with this modern piece of equipment. αντικό: PC-7612V PC-7614V English (Original instructions) Congratulations on choosing a DOLMAR Power Cutter!Failure to observe these precautions can lead to severe injury or death! [. . . ] Vibration may cause the following symptoms to occur in the fingers, hands or wrists: “Falling asleep” (numbness), tingling, pain, stabbing sensation, alteration of skin colour or of the skin. Torque Idling speed Clutch Clutch engagement speed Engine speed limitation Max. Spindle speed Carburetor Ignition system (with speed limitation) Spark plug Electrode gap Starting system Fuel consumption at max. 1 API grade SF class or higher SAE 10W-30 oil (automobile 4-stroke engine oil) 0. Overall weight (tanks empty, without cutting disc) 1) Circumference speed at max. Engine speed 2) Outside diameter / arbor hole / thickness 3) At the workplace (at user’s ear) no. Throttle lever 5 4 3 2 6 7 1 9 8 10 12 11 14 13 18 15 16 17 19 20 12 PUTTING INTO OPERATION CAUTION: Always turn off the engine and pull off the spark plug cap before doing any work on the Power Cutter!CAUTION: Start the Power Cutter only after complete assembly and inspection. For the following work, use the assembly tools included with delivery: 1. 13/16 AF combination wrench Star-sharped wrench Carburetor adjustment screwdriver Adapter ring Place the Power Cutter on a stable surface and carry out the following assembly steps: No air filter is installed!Before operation, squeeze the supplied filter several times so that oil is evenly immersed in the entire filter. insert an oiled foam filter (pre-filter) , as shown in the adjacent illustration!To do this, take off the filter cover (see the chapter on Cleaning/ changing the air filter). Mounting the cutting disc Schematic drawing WARNING: • When installing a diamond cutting disc, be sure to mount it so that the arrow is in the same direction as the outer flange (6) rotates. Mounting the diamond cutting disc (4) with its arrow direction opposite to that on the wheel cover may cause chipping of the disc edge and personal injury. € When installing a cutting disc (4), always use the ring that matches the bore of the cutting disc and the diameter of the spindle (5). Failure to use rings that mate may cause tool vibration resulting in serious personal injury. € Only use cutting discs with the bore that matches the diameter of the ring(s) provided. Using discs that do not mate may cause tool vibration resulting in serious personal injury.  Insert the star-shaped wrench (2) into the hole (8) to prevent the spindle (5) from rotating. NOTE:  When the holder of the pressure water system is installed in the hole in the tool, remove it before mounting the cutting disc.  While holding on the wrench (2) in that position, use the combination wrench (1) provided and turn the bolt (7) securing the disc counterclockwise and remove the bolt (7) and outer flange (6). [. . . ] The water line has a fast-release connection, and can be fed either from a mains supply or from a pressure tank (7). Guide trolley The DOLMAR guide trolley makes it much easier to do straight cuts, while simultaneously enabling almost untiring working. It can be adjusted for the operator’s height, and can be operated with the cutting attachment mounted in the middle or on the side. A depth limiter can be added for still easier and more accurate cutting. [. . . ]