User manual MAKITA MT370

[. . . ] This enables better control of the power tool in unexpected situations. If devices are provided for the connection of dust extraction and collection facilities, ensure these are connected and properly used. The correct power tool will do the job better and safer at the rate for which it was designed. Any power tool that cannot be controlled with the switch is dangerous and must be repaired. [. . . ] in accordance with these instructions and in the manner intended for the particular type of power tool, taking into account the working conditions and the work to be performed. Use of the power tool for operations different from those intended could result in a hazardous situation. Have your power tool serviced by a qualified repair person using only identical replacement parts. This will ensure that the safety of the power tool is maintained. ADDITIONAL SAFETY RULES 1. Hold tool by insulated gripping surfaces when performing an operation where the cutting tool may contact hidden wiring or its own cord. Contact with a "live" wire will make exposed metal parts of the tool "live" and shock the operator. Make sure the bit is not contacting the workpiece before the switch is turned on. Watch for vibration or wobbling that could indicate improperly installed bit. ENB055-1 11. Always switch off and wait for the bit to come to a complete stop before removing the tool from workpiece. Do not touch the bit immediately after operation; it may be extremely hot and could burn your skin. Always lead the power supply cord away from the tool towards the rear. Do not smear the tool base carelessly with thinner, gasoline, oil or the like. Draw attention to the need to use cutters of the correct shank diameter and which are suitable for the speed of the tool. This tool should be grounding while in use to protect the operator from electric shock. Use only three-wire extension cords which have three-prong groundingtype plugs and three-pole receptacles which accept the tool's plug. Be careful of the bit rotating direction and the feed direction. SAVE THESE INSTRUCTIONS 4 FUNCTIONAL DESCRIPTION · CAUTION: Always be sure that the tool is switched off and unplugged before adjusting or checking function on the tool. 005431 Adjusting bit protrusion To adjust the bit protrusion, loosen the clamping screw and move the tool base up or down as desired. After adjusting, tighten the clamping screw firmly to secure the tool base. 1 3 2 4 1. 4. Base Scale Bit protrusion Clamping screw 005432 Switch action CAUTION: · Before plugging in the tool, always be sure that the tool is switched off. Switch lever ASSEMBLY · CAUTION: Always be sure that the tool is switched off and unplugged before carrying out any work on the tool. 005433 Installing or removing trimmer bit CAUTION: Do not tighten the collet nut without inserting a bit, or the collet cone will break. Insert the bit all the way into the collet cone and tighten the collet nut securely with the two wrenches. Hold 5 OPERATION Set the tool base on the workpiece to be cut without the bit making any contact. Move the tool forward over the workpiece surface, keeping the tool base flush and advancing smoothly until the cutting is complete. [. . . ] Bolt Guide plate Straight guide Flat washer Wave washer Wing nut Attach the guide plate to the straight guide with the bolt, the wave washer, the flat washer and the wing nut. 7 004559 1 2 Remove the chip deflector. Loosen the wing nut on the straight guide and adjust the distance between the bit and the straight guide. When cutting, move the tool with the straight guide flush with the side of the workpiece. 4 1. 4. 3 Clamp screw (A) Straight guide Wing nut Base 005437 A If the distance (A) between the side of the workpiece and the cutting position is too wide for the straight guide, or if the side of the workpiece is not straight, the straight guide cannot be used. [. . . ]