User manual MAKITA MOTEUR PM5360 S3 120000

[. . . ] These numbers are located on your engine (see the Features and Controls page). The engine exhaust from this product contains chemicals known to the State of California to cause cancer, birth defects, or other reproductive harm. WARNING Date of purchase: Engine model: Model: MM/DD/YYYY Type: Code: Briggs & Stratton does not approve or authorize the use of these engines on 3-wheel All Terrain Vehicles (ATVs), motor bikes, fun/recreational go-karts, aircraft products, or vehicles intended for use in competitive events. Use of these engines in such applications could result in property damage, serious injury (including paralysis), or even death. [. . . ] WARNING: Replacement parts must be the same and installed in the same position as the original parts or fire could result. First 5 Hours • Change oil ro d WARNING Maintenance Chart How To Change The Oil - Figure 1 uc Every 8 Hours or Daily • • • Check engine oil level Clean area around muffler and controls Clean finger guard Every 25 Hours or Annually • • Clean air filter * Clean pre-cleaner * Every 50 Hours or Annually • • Change engine oil Check muffler and spark arrester rR Annually • • • • • * Replace air filter Replace pre-cleaner Replace spark plug Replace fuel filter Clean air cooling system * fo In dusty conditions or when airborne debris is present, clean more often. Ot N Carburetor Adjustment Never make adjustments to the carburetor. However, if adjustments are required, see any Briggs & Stratton Authorized Dealer for service. NOTICE: The manufacturer of the equipment on which this engine is installed specifies the top speed at which the engine will be operated. How To Replace The Spark Plug - Figure 9 Check the gap (A, Figure 9) with a wire gauge (B). Note: In some areas, local law requires using a resistor spark plug to suppress ignition signals. If this engine was originally equipped with a resistor spark plug, use the same type for replacement. If you drain the oil from the top oil fill tube, the fuel tank must be empty or fuel can leak out and result in a fire or explosion. Used oil is a hazardous waste product and must be disposed of properly. Check with your local authorities, service center, or dealer for safe disposal/recycling facilities. Remove Oil You can drain the oil from the bottom drain hole, the side drain hole, or from the top oil fill tube. With engine off but still warm, disconnect the spark plug wire (A) and keep it away from the spark plug (Figure 10). The engine is equipped with a bottom drain (Q, Figure 1) and/or a side drain (R). Note: Any of the oil drain plugs (H) shown may be installed in the engine. If you drain the oil from the top oil fill tube (E), keep the spark plug end of the engine (F) up (Figure 11). WARNING: If you drain the oil from the top oil fill tube, the fuel tank must be empty or fuel can leak out and result in a fire or explosion. To empty the fuel tank, run the engine until it stops from lack of fuel. 8 tio 10 11 12 Before performing adjustments or repairs: • Disconnect the spark plug wire and keep it away from the spark plug. € Do not tamper with governor spring, links or other parts to increase engine speed. € Replacement parts must be the same and installed in the same position as the original parts. COM How To Service The Air Filter - Figure 14 WARNING Gasoline and its vapors are extremely flammable and explosive. [. . . ] € • Manufacturer’s Warranty Coverage: Small off-road engines are warranted for two years. If any emissions-related part on your engine/equipment is defective, the part will be repaired or replaced by B&S. Warranted Emissions Parts Coverage under this warranty extends only to the parts listed below (the emissions control systems parts) to the extent these parts were present on the engine purchased. Fuel Metering System • Cold start enrichment system (soft choke) • Carburetor and internal parts • Fuel pump • Fuel line, fuel line fittings, clamps • Fuel tank, cap and tether • Carbon canister b. [. . . ]