User manual MAKITA HT2162E

[. . . ] C English / Français / Spanish HEDGE TRIMMER TAILLE-HAIES CORTASETOS HT-2145 D HT-2162 E INSTRUCTION MANUAL MANUEL D’INSTRUCTIONS MANUAL DE INSTRUCCIONES HT-2145 D HT-2162 E WARNING: To reduce the RISK of injury, user must read and understand the instruction manual before using the Hedge Trimmer. Manufacturer reserves the right to change specifications without notice. We are pleased to be able to offer you the DOLMAR Hedge Trimmer which is the result of a long development program and many ears of knowledge and experience. The Hedge Trimmer models HT-2145 D/HT-2162 E combines the advantages of state-of-the-art technology with ergonomic design, they are light weight, handy, compact and represent professional equipment for a great variety of applications. [. . . ] Diagrammatic figure 9 STARTING THE MACHINE Move at least 3 meters away from the place of refuelling. Place the Hedge Trimmer on a clean area of ground make sure that the cutting tool does not come into contact with the ground or any other objects. Cold starting (When the engine is cold or it has been stopped for more than 5 minutes or when fuel is added to the engine. Keeping the throttle lever B depressed, then press the throttle lock C inward. Hold the unit down firmly so you will not lose control while cranking the engine. If not held down properly, the engine could pull you off balance or swing the cutting blade into an obstruction or your body. Slowly pull the starter grip until resistance is felt and continue with smart pull until initial ignition are heard. Depress the choke lever (3) to the position ( ) and pull the starter rope again until the engine starts. As soon as the engine starts, immediately tap and release the throttle, thus releasing the half-throttle lock so that the engine can run in idle. Run the engine for approximately one minute at a moderate speed before applying full speed. HT-2162 E HT-2145 D HT-2162 E (1) Hot staring: (Restarting immediately after the engine has stopped) When restarting a hot engine, first try the above procedure: 1, 5, 7, 8. Note: Do not pull the starter rope to its full extent and do not allow the starter grip to be retracted without control, ensure that it is retracted slowly. Push the STOP switch (on/off switch) to “O” position, the engine rotation will become low. HT-2145 D HT-2162 E 10 OPERATION OF THE MACHINE – Be sure to carefully read and follow safety instructions. Never grasp the exposed cutting blade or cutting edges, when picking up or holding the tool. € Never touch the cutting device when starting the engine and during operation. € Operate the Hedge Trimmer in such a manner as to avoid inhalation of the exhaust gases. € All protective installations and guards supplied with the machine must be used during operation. € Never operate the engine with a faulty exhaust muffler or if it is missing. € Never climb up the trees with the Hedge Trimmer to perform cutting operation. € Before commencing cutting, the cutting blades must have reached full working speed. € Always hold the Hedge Trimmer firmly with both hands on the handles only. [. . . ] , La Mirada, California, (herein “MAKITA”) warrant to the initial retail purchaser and each subsequent owner, that this utility equipment engine (herein “engine” ) was designed, built, and equipped to conform at the time of initial sale to all applicable regulations of the U. Environmental Protection Agency (EPA), and that the engine is free of defects in materials and workmanship which would cause this engine to fail to conform with EPA regulations during its warranty period. PARTS COVERED Listed below are the parts covered by the Emission Component Defect Warranty. Some of the parts listed below may require scheduled maintenance and are warranted up to the first scheduled replacement point for that part. [. . . ]