User manual MAKITA HR4002 ANNEXE 893

[. . . ] Power supply The tool should be connected only to a power supply of the same voltage as indicated on the nameplate, and can only be operated on single-phase AC supply. They are double-insulated in accordance with European Standard and can, therefore, also be used from sockets without earth wire. The declared vibration emission value has been measured in accordance with the standard test method and may be used for comparing one tool with another. [. . . ] CAUTION: Always be sure that the tool is switched off and unplugged before adjusting or checking function on the tool. 1 CAUTION: Before plugging in the tool, always check to see that the switch trigger actuates properly and returns to the "OFF" position when released. CAUTION: Do not rotate the change lever when the tool is running under load. To avoid rapid wear on the mode change mechanism, be sure that the change lever is always positively located in one of the two or three action mode positions. Coat the bit shank head beforehand with a small amount of bit grease (about 0. After installing, always make sure that the bit is securely held in place by trying to pull it out. To remove the bit, pull the chuck cover down all the way and pull the bit out. The torque limiter will actuate when a certain torque level is reached. CAUTION: As soon as the torque limiter actuates, switch off the tool immediately. Then make sure that the bit is securely held in place by turning it slightly. CAUTION: Always be sure that the tool is switched off and unplugged before carrying out any work on the tool. The side handle can be swung 360° on the vertical and secured at any desired position. It also secures at eight different positions back and forth on the horizontal. Adjust the depth gauge to the desired depth and then tighten the clamp screw to secure the depth gauge. nOTE: · The depth gauge cannot be used at the position where the depth gauge strikes against the tool body. ⷠThe depth gauge cannot be used at the position where the depth gauge strikes against the gear housing/motor housing. 6 CAUTION: Always use the side grip to ensure operating safety when drilling in concrete, masonry, etc. The side grip swings around to either side, allowing easy handling of the tool in any position. [. . . ] Turn the tool on and apply slight pressure on the tool so that the tool will not bounce around, uncontrolled. CAUTION: Always be sure that the tool is switched off and unplugged before attempting to perform inspection or maintenance. This tool requires no hourly or daily lubrication because it has a grease-packed lubrication system. [. . . ]