User manual MAKITA HP330D

[. . . ] Hold power tool by insulated gripping surfaces, when performing an operation where the cutting accessory may contact hidden wiring. Cutting accessory contacting a “live” wire may make exposed metal parts of the power tool “live” and could give the operator an electric shock. WARNING: DO NOT let comfort or familiarity with product (gained from repeated use) replace strict adherence to safety rules for the subject product. MISUSE or failure to follow the safety rules stated in this instruction manual may cause serious personal injury. [. . . ] FUNCTIONAL DESCRIPTION CAUTION: • Always be sure that the tool is switched off and the battery cartridge is removed before adjusting or checking function on the tool. 3) CAUTION: • Do not look in the light or see the source of the light directly. Be careful not to scratch the lens of lamp, or it may lower the illumination. 1) CAUTION: • Always switch off the tool before installing or removing of the battery cartridge. When the reversing switch lever is in the neutral position, the switch trigger cannot be pulled. CAUTION: • Always check the direction of rotation before operation. € Use the reversing switch only after the tool comes to a complete stop. Changing the direction of rotation before the tool stops may damage the tool. € When not operating the tool, always set the reversing switch lever to the neutral position. NOTE: • The fastening torque can be adjusted only when the arrow points toward the mark on the ring. ASSEMBLY CAUTION: • Always be sure that the tool is switched off and the battery cartridge is removed before carrying out any work on the tool. Be sure that the speed change lever is set to the correct position before operation. CAUTION: • Always set the speed change lever fully to the correct position. 9) CAUTION: • Always insert the battery cartridge all the way until it locks in place. Otherwise, it may accidentally fall out of the tool, causing injury to you or someone around you. CAUTION: • Do not cover vents, or it may cause overheating and damage to the tool. Select one of the three modes suitable for your work needs by using this ring. If you operate the tool with the ring positioned halfway between the mode marks, the tool may be damaged. Hammer drilling operation CAUTION: • There is a tremendous and sudden twisting force exerted on the tool/bit at the time of hole breakthrough, when the hole becomes clogged with chips and particles, or when striking reinforcing rods embedded in the concrete. First, turn the action mode changing ring so that the arrow on the tool body points to the marking. [. . . ] € Turn off the tool and wait until it comes to a complete stop before placing it in the holster. Be sure to close the holster securely so that it holds the tool firmly. MAINTENANCE CAUTION: • Always be sure that the tool is switched off and the battery cartridge is removed before performing any inspection or maintenance. To maintain product SAFETY and RELIABILITY, repairs, any other maintenance or adjustment should be performed by Makita Authorized Service Centers, always using Makita replacement parts. [. . . ]