User manual MAKITA HP1630K

[. . . ] Use of 2 Intended use The tool is intended for impact drilling in brick, concrete and stone as well as for drilling without impact in wood, metal, ceramic and plastic. ENF002-1 Power supply The tool should be connected only to a power supply of the same voltage as indicated on the nameplate, and can only be operated on single-phase AC supply. They are double-insulated in accordance with European Standard and can, therefore, also be used from sockets without earth wire. GEA005-2 General Power Tool Safety Warnings WARNING Read all safety warnings and all instructions. Failure to follow the warnings and a cord suitable for outdoor use reduces the risk of electric shock. If operating a power tool in a damp location is unavoidable, use a ground fault circuit interrupter (GFCI) protected supply. [. . . ] Check for misalignment or binding of moving parts, breakage of parts and any other condition that may affect the power tool's operation. Properly maintained cutting tools with sharp cutting edges are less likely to bind and are easier to control. in accordance with these instructions, taking into account the working conditions and the work to be performed. Use of the power tool for operations different from those intended could result in a hazardous situation. Have your power tool serviced by a qualified repair person using only identical replacement parts. Keep handles dry, clean and free from oil and grease. GEB003-2 SPECIFIC SAFETY RULES DO NOT let comfort or familiarity with product (gained from repeated use) replace strict adherence to hammer drill safety rules. If you use this power tool unsafely or incorrectly, you can suffer serious personal injury. Hold power tools by insulated gripping surfaces when performing an operation where the cutting tool may contact hidden wiring or its own cord. Contact with a "live" wire will make exposed metal parts of the tool "live" and shock the operator. Do not touch the bit or the workpiece immediately after operation; they may be extremely hot and could burn your skin. Reversing switch lever A B 1 008898 SAVE THESE INSTRUCTIONS. WARNING: MISUSE or failure to follow the safety rules stated in this instruction manual may cause serious personal injury. This tool has a reversing switch to change the direction of rotation. Move the reversing switch to the position (A side) for clockwise rotation or the position (B side) for counterclockwise rotation. Use the reversing switch only after the tool comes to a complete stop. Changing the direction of rotation before the tool stops may damage the tool. If the switch trigger can not be depressed, check to see that the reversing switch is fully set to position (A side) or (B side). FUNCTIONAL DESCRIPTION · · CAUTION: Always be sure that the tool is switched off and unplugged before adjusting or checking function on the tool. · Switch action 1. Action mode change lever 1 2 008893 CAUTION: · Before plugging in the tool, always check to see that the switch trigger actuates properly and returns to the "OFF" position when released. · Switch can be locked in "ON" position for ease of operator comfort during extended use. Apply caution when locking tool in "ON" position and maintain firm grasp on tool. For continuous operation, pull the switch trigger and then push in the lock button. To stop the tool from the locked position, pull the switch trigger fully, then release it. 1 008894 This tool has an action mode change lever. For rotation with hammering, slide the action mode change lever to the right ( symbol). For rotation only, slide the action mode change lever to the left ( symbol). [. . . ] To remove the bit, turn the chuck key counterclockwise in just one hole, then loosen the chuck by hand. 008899 5 CAUTION: There is a tremendous and sudden twisting force exerted on the tool/bit at the time of hole break-through, when the hole becomes clogged with chips and particles, or when striking reinforcing rods embedded in the concrete. Always use the side grip (auxiliary handle) and firmly hold the tool by both side grip and switch handle during operations. Failure to do so may result in the loss of control of the tool and potentially severe injury. When drilling in concrete, granite, tile, etc. , move the action mode changing lever to the position of symbol to use "rotation with hammering" action. [. . . ]