User manual MAKITA GA7020SF

[. . . ] Always be sure that the tool is switched off and unplugged before carrying out any work on the tool. Use only wheels with correct size and wheels having a maximum operating speed at least as high as the highest No Load Speed marked on the tool's nameplate. When using depressed center wheels, be sure to use only fiberglass reinforced wheels. Observe the instructions of the manufacturer for correct mounting and use of wheels. [. . . ] Cutting discs must not be subjected to any lateral pressure For tool with the lock-on switch To start the tool, simply pull the switch trigger (in the B direction). For continuous operation, pull the switch trigger (in the B direction) and then push in the lock lever (in the A direction). To stop the tool from the locked position, pull the switch trigger fully (in the B direction), then release it. For tool with the lock-off switch To prevent the switch trigger from accidentally pulled, a lock lever is provided. To start the tool, push in the lock lever (in the A direction) and then pull the switch trigger (in the B direction). For tool with the lock on and lock-off switch To prevent the switch trigger from accidentally pulled, a lock lever is provided. To start the tool, push in the lock lever (in the A direction) and then pull the switch trigger (in the B direction). For continuous operation, push in the lock lever (in the A direction), pull the switch trigger (in the B direction) and then push the lock lever (in the A direction) further in. To stop the tool from the locked position, pull the switch trigger fully (in the B direction), then release it. NOTE: Models GA7020S, GA9020S, GA7020SF and GA9020SF begin to run slowly when they are turned on. This soft start feature assures smoother operation and less operator fatigue. Always be sure that the tool is switched off and unplugged before carrying out any work on the tool. Always be sure that the tool is switched off and unplugged before adjusting or checking function on the tool. Always be sure that the side grip is installed securely before operation. Press the shaft lock to prevent spindle rotation when installing or removing accessories. The wheel guard must be fitted on the tool so that the closed side of the guard always points toward the operator. Mount the wheel guard with the protrusion on the wheel guard band aligned with the notch on the bearing box. Before plugging in the tool, always check to see that the switch trigger actuates properly and returns to the "OFF" position when released. Fit the wheel/disc on the inner flange and screw the lock nut onto the spindle. Always be sure that the tool is switched off and unplugged before attempting to perform inspection or maintenance. [. . . ] The use of any other accessories or attachments might present a risk of injury to persons. If you need any assistance for more details regarding these accessories, ask your local Makita Service Center. Wheel guard (Wheel cover) Inner flange Depressed center wheels Lock nut (For depressed center wheel) Rubber pad Abrasive discs Lock nut (For abrasive disc) Lock nut wrench Cut-off wheels Inner flange (For cut-off wheel) Outer flange (For cut-off wheel) Wire cup brush Side grip Dust collecting wheel guard ALWAYS hold the tool firmly with one hand on rear handle and the other on the side handle. In general, keep the edge of the wheel or disc at an angle of about 15 degrees to the workpiece surface. [. . . ]