User manual MAKITA DF030DW

[. . . ] Avoid body contact with earthed or grounded surfaces such as pipes, radiators, ranges and refrigerators. There is an increased risk of electric shock if your body is earthed or grounded. Never use the cord for carrying, pulling or unplugging the power tool. When operating a power tool outdoors, use an extension cord suitable for outdoor use. [. . . ] If electrolyte gets into your eyes, rinse them out with clear water and seek medical attention right away. Do not short the battery cartridge: (1) Do not touch the terminals with any conductive material. (2) Avoid storing battery cartridge in a container with other metal objects such as nails, coins, etc. A battery short can cause a large current flow, overheating, possible burns and even a breakdown. Do not store the tool and battery cartridge in locations where the temperature may reach or exceed 50 C (122 F). Do not incinerate the battery cartridge even if it is severely damaged or is completely worn out. 3. 4. SPECIFIC SAFETY RULES DO NOT let comfort or familiarity with product (gained from repeated use) replace strict adherence to drill safety rules. If you use this power tool unsafely or incorrectly, you can suffer serious personal injury. Hold power tools by insulated gripping surfaces when performing an operation where the cutting tool may contact hidden wiring or its own cord. Contact with a "live" wire will make exposed metal parts of the tool "live" and shock the operator. Do not touch the drill bit or the workpiece immediately after operation; they may be extremely hot and could burn your skin. 4 5. 6. 7. 8. SAVE THESE INSTRUCTIONS. Tips for maintaining maximum battery life 1. Always stop tool operation and charge the battery cartridge when you notice less tool power. Never recharge a fully charged battery cartridge. 2. 3. Overcharging shortens the battery service life. Charge the battery cartridge with room temperature at 10 C - 40 C (50 F - 104 F). Let a hot battery cartridge cool down before charging it. actuates properly and returns to the "OFF" position when released. Release the switch trigger to stop. FUNCTIONAL DESCRIPTION · Turning on the front lamp 1. Lamp CAUTION: Always be sure that the tool is switched off and the battery cartridge is removed before adjusting or checking function on the tool. 1 008798 Installing or removing battery cartridge 1 1. Battery cartridge 2 008797 CAUTION: Do not look in the light or see the source of the light directly. The lamp turns off 10 -15 seconds after releasing the trigger. · · · · · Always switch off the tool before insertion or removal of the battery cartridge. To remove the battery cartridge, withdraw it from the tool while pressing the buttons on both sides of the cartridge. To insert the battery cartridge, hold it so that the battery cartridge front shape fits to that of the battery installment opening and slip it into place. [. . . ] Put the tool in the holster and lock it with the holster button. 008807 Using the tool as a hand screwdriver 008808 Two bits can be retained at the front of holster. 008806 Switch off the tool. NOTE: · Use the tool with a fastening torque less than 12. 5 Nm (127 kgf. cm). · Do not use the tool for work requiring excessive force, such as tightening bolt or removing rusted screws. 008809 MAINTENANCE CAUTION: Always be sure that the tool is switched off and the battery cartridge is removed before attempting to perform inspection or maintenance. To maintain product SAFETY and RELIABILITY, repairs, any other maintenance or adjustment should be performed by Makita Authorized Service Centers, always using Makita replacement parts. · Using holster · · CAUTION: Do not use for tools such as a drill with a bit installed on them. [. . . ]